Installation guide for Cisco TelePresence MX700 Single camera - Floor stand
9
Fasten right monitor to floor stand and connect power cable
Connect power cable
2
Connect the loose end of
the power cable from step 7
to the close-by socket at
the rear of the right monitor.
The socket must be reached
from below.
Make sure that the power
switch next to the socket is
in its ON position.
78-100218-03A0 | 2018 JUNE | © 2018 Cisco Systems, Inc. All rights reserved.
4 ×
M6x90, countersunk
4 ×
M6x35, countersunk
Enter four screws from
1
front and four screws from
underneath. Then, tighten
all screws.
Page 14