Installation Manual
11 Installation of the Decorative Panel
11.1 Remove Front Grille
Slide the 2 grille hooks in the middle of the decorative panel.
1
2
Figure 46
1. Intake grille
2. Grille hook
Open the intake grille and detach from decorative panel.
Figure 47
11.2 Remove Corner Covers of the Panel
(24k and 48k models only)
Figure 48
Bosch Thermotechnology Corp. | 04.2019
Bosch Climate 5000 Series Four Way Cassette Ductless Single Split Air Conditioner / Heat Pump | 27
11.3 Install the Decorative Panel
Instruction for 9k ~ 18k models only
Figure 49
1. Decorative panel
2. Screws (M5)(supplied with the panel)
Instruction for 24k and 48k models only
Figure 50
Align the "△" symbol on the decorative panel to the "△" symbol on
the unit.
Attach the decorative panel to the unit with the supplied screws as
shown in figure below.
Align the front panel to the main body, taking into account the
position of the piping and drain sides. Hang the four latches of the
decorative panel to the hooks of the indoor unit. Tighten the panel
hook screws evenly at the four corners.
Tighten the screws until the thickness of the sponge between the main
body and the panel reduces to 4-6mm (0.2-0.3in). The edge of the
panel should be in contact with the ceiling tightly.
Latch
Piping side
Drain side
Screwdriver
1
2
Data subject to change