REEF ONE Baby BiOrb Quick Start Manual

This guide will help you understand how
your aquarium works and how to create a
healthy environment for your fish. Please
read these instructions carefully before
filling your aquarium with water.
This is not a toy, adult supervision is
recommended. Removing the serial
number or dismantling your aquarium
will invalidate your guarantee.
Setting up your aquarium
1 Carefully remove contents from the
box and check. Choose a suitable
location for your aquarium noting all
the advice above and place your
aquarium on a strong and level surface.
Remember the aquarium needs a
power source within reach.
2 Remove plastic wrapper from filter
cartridge (A) then offer up cartridge to
base of bubble tube (B), locate tabs and
twist in a counterclockwise direction
ensuring all cartridge tabs are fully
located. new cartridges are available
from a biorb dealer.
3 Remove the light unit and lid from the
biOrb then take the bubble tube and
1
4 US gals = 40lbs
15 l = 18 kg
5
L
NOT ON OR NEAR
ELECTRICAL ITEMS
filter cartridge assembled in step 2 and
insert into the biOrb. Turn the bubble tube
clockwise until it locks in position. When
correctly located, the bubble tube and filter
will remain in place.
4 Wash the ceramic media supplied
thoroughly before placing around the
filter body, ensuring none remains on top.
Use only ceramic media supplied, do not
use aquarium gravel. Discard any pieces
smaller than a pea.
5 Connect the airline to the pump as shown
and place in a suitable position. Positioning
the pump higher than the aquarium water
level will prevent water leakage or damage
to pump should valve failure occur.
2
6
UK 01603 710339 UK 01603 710339
US 877-928-7333 US 877-928-7333
L
DO NOT MOVE
WHEN FULL HOT AREAS
6 Plug the pump and light unit plug
into the separate sockets on the
transformer supplied, then plug the
transformer into the power source and
turn on. The pump should be left
running 24hrs a day, only switch it
off during filter cartridge changes
and cleaning.
7 Fill the aquarium with tap water to
approximately 2"/5 cm above the top
of the bubble tube and add Water
Conditioner.
8 Leave the aquarium running for at
least 24hrs before adding Biological
Booster and then you will be ready to
add your first fish. Do noT immerse
the light unit in water.
3
7
2" - 5cm
FR 0811 850 113 FR 0811 850 113 info@reef-one.com info@reef-one.com
DE 0800-181-9091 DE 0800-181-9091 www.reef-one.com www.reef-one.com
L
AVOID IMPORTANT:
AVOID SUNLIGHT
4
8
L