ThermoWorks WAND Quick Reference

ThermoWorks WAND

Measuring Forehead Temperatures

Quick, Easy, and Reliable!

Power on device

Point at center of

forehead 1–2 inches

away

Press and hold START for 1 second—

a single beep tells you it's done

WAND is pre-set to forehead mode and to display temperature in

Fahrenheit. Three short beeps followed by one long beep while taking a

forehead reading means that the temperature exceeded 99.5°F (37.5°C).

Please wait 2 seconds between measurements.

For warranty, service, and technical assistance, please contact ThermoWorks' Technical

Support at (801) 756-7705 or email techsupport@thermoworks.com.

www.thermoworks.com/wand | 801-756-7705

Quick Reference

Technical Support

™

Table of Contents

Need help?

Do you have a question about the WAND and is the answer not in the manual?

Page 1 Press and hold START for 1 second— a single beep tells you it’s done WAND is pre-set to forehead mode and to display temperature in Fahrenheit. Three short beeps followed by one long beep while taking a forehead reading means that the temperature exceeded 99.5°F (37.5°C).
Page 2 Units will change. Cautions • Forehead should be clean, dry, and unobstructed before taking readings. • WAND is not waterproof. Avoid wet areas and splashes. • Do not expose device to temperatures above 100°F (38°C) or below 50°F (10°C).