The Remote Control Battery; How To Use The Remote Control; Replacement Parts - Chamberlain 950ESTD-P2 Instructions

THE REMOTE CONTROL BATTERY

The lithium battery should produce power for up to 5 years. If the battery is low, the remote control's LED will
not flash when the button is pressed. To replace battery:
Pry open the case first Remove the old battery.
in the middle (1), then Dispose of old batteries
at each side (2 and 3) properly.
with the visor clip.
3
1
2

HOW TO USE THE REMOTE CONTROL

Press and hold the button down until the door or gate
starts to move. The remote control will operate from
up to 3 car lengths away on typical installations.
Installations and conditions vary, contact an installing
dealer for more information.

REPLACEMENT PARTS

3V CR2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor Clip . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
114A5256
Replace the cover.
Insert the replacement
battery positive side up.
Replace the battery
with only 3V CR2032
coin cell batteries.
3V CR2032
ONE YEAR LIMITED WARRANTY
The Chatmberlain Group, Inc. warrants to the first consumer purchaser of this product that it is
free from defect in materials and/or workmanship for a period of 1 year from the date of purchase.
© 2018, The Chamberlain Group, Inc.
All Rights Reserve
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V CR2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212° F (100° C) or incinerate.
NOTICE: This device complies with Part 15 of the FCC rules and Industry Canada's license-exempt RSSs.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause
undesired operation. Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC rules and Industry Canada ICES standard. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
www.chamberlain.com
support.chamberlaingroup.com