Twine Specifications; Knotter And Needle Specifications; Bale Chamber Tension Specifications; Ejector Specifications - FENDT 1290 UD Workshop Service Manual

1.3.1.9 Twine specifications

Type
Storage capacity
Minimum knot strength
Plunger load set below 465 kN
Plunger load set from 465 kN to 600 kN
Plunger load set above 600 kN
Twine not made for use in this machine will not work correctly. Low quality, incorrect type, or incorrect
strength twine can cause knotter malfunction, and knotter and twine failures.
Crop with more spring-back will have to have stronger twine.

1.3.1.10 Knotter and needle specifications

Knotter quantity
Knotter type
Knotter spacing
Needle quantity
Protection
Knotter/needle lockout
Needle protection linkage

1.3.1.11 Bale chamber tension specifications

Control
Actuation
System supply

1.3.1.12 Ejector specifications

Number of teeth
Slide type
Power
Cylinder diameter
Cylinder stroke
Valve
Operation
Large Square Baler
79037317B
High quality split film polypropylene
twine for low and middle force loads.
AGCO® brand twine for high force loads.
36 balls
Twine rated for 2000 N to 2450 N (450
lbf to 551 lbf)
Twine rated for 2891 N to 3336 N (650 lbf
to 750 lbf)
AGCO® brand twine rated at 3336 N and
above (750 lbf and above)
6
double knot
176 mm (6.9 in)
6
Shearbolt on the main drive sprocket
Switch by the left rear corner of the bale
chamber
Automatic, link to needle carriage
Manual or automatic control hydraulics
Spool type solenoid valve
Open center on board hydraulics
12
Ball bearing rollers
Hydraulic cylinder
64 mm (2.5 in)
914 mm (36 in)
Enable valve/control valve
Switch and teeth selection at rear
1. General
GUID-2E186457-8B05-4204-AA26-D36C508F73BE [V1]
GUID-CD6992A9-182A-4431-B8CC-FD25225C6DBD [V1]
GUID-708B34DF-55F2-48EB-BD44-FAB8DCCD686D [V2]
GUID-17E4B1BA-CC96-4640-9293-7D1635E9DFF2 [V1]
1-25