Advertisement
INSTALLATION INSTRUCTIONS
-Rough in the valve, orienting the
mud guard #2 flush with the finish
wall ( You can recess up to 1/4").
-Screw the all thread extension
#4 onto the volume control /
diverter valve until it stops.
-Screw
threaded sleeve #11 and put the
broach extension #10 onto the
thermostatic stem.
-Put the diverter broach extension
#5 onto the volume control /diverter
valve.
-Repeat step D for the broach
extension.
-Replace the newly cut diverter
broach extension and all thread
extension #4 back onto the valve.
-
u
pwards to the 12 oclock position over the extension broach #10.
-Secure with the provided long screw #15 and cut excess length to
fit Assemble the thermostatic handle #16 onto the thermostatic
dial and tighten with the the set screw #9 ensuring the handle
faces the 6 o' clock position.
on
the
thermostatic
Insert the thermostatic dial #14 with the "100" mark oriented
-Remove the plastic mud guard #2.
- Place #3 Plate up against wall over
valve.
-Slide #6 diverter ring over #4 all
thread extension.
-Thread #7 ON/OFF handle to #4 all
thread extension
-Measure distance between front of
#6 diverter ring and back of #7 ON/
OFF handle
- Remove ON/OFF handle and cut
required amount of thread from #4
required to attach #7 ON/OFF
handle flush to #3 plate.
-Cut #5 diverter broach extension
approximately
past #4 all thread
1/4"
extension to allow #7 ON/OFF
handle to attach
-Replace the plate #3 and diverter ring
#6.
-Hand tighten the thermostatic flange
#12 to the threaded sleeve #11.
-Place the On/Off handle assembly #7
onto the diverter broach extension #5
and hand tighten the escutcheon.
Make sure le ver is oriented up
towards the 12'oclock position.
0 3
Advertisement
