Advertisement
DINING TABLE
ASSEMBLY – STEP 2: FIT LEG PEDESTAL/BRACE COMPONENT TO "TABLE RIM".
Lay Table Rim [A] flat upside down as indicated in diagram below.
With the help of a second person in unison lift assembled components "pedestal
& brace" place as indicated in diagram, aline holes in pedestal with threaded
holes in table rim. Then by hand take bolt & washer [E+F] insert thru hole into
threaded hole, ensure to seat thread properly and by hand turn 2-3 times so
that thread has proper grip. Repeat for other side of pedestal. Repeat for other
pedestal. Once all bolts are attached, have second person hold pedestal in posi-
tion ensure that pedestal is in correct square position before you tighten bolts.
Take Tool [H] insert into end of bolt rotate in clockwise direction till bolt is firm
do not overtighten as this can cause damage to threads, repeat for all bolts in
table rim, then take tool and tighten bolts in pedestal leg, repeat till bolts are
tightened. Next take bolt cover caps [G] and push onto ends of bolts.
Go to step 3.
Advertisement
