Roper Rhodes TR9016 Installation & Operation Instructions

Dual Flush Sensor Flush Plate
Installation & Operation Instructions - For Domestic Use Only
Please read completely before commencing. Retain for future reference
Introduction
This sensor ush plate is compatible with wall hung frame cisterns and In-wall cisterns from Roper Rhodes
Group.
For In-wall installation the front of frame to front of nished wall minimum depth should be 15.5mm.
If used with a furniture concealed cistern ensure a clearance of 105mm is left between the cistern and the front
of the furniture fascia surface to allow adequate installation.
Battery Installation
(Batteries not included)
Open the glass plate by pushing it towards the top and then tilting it
forwards. The clip chain will allow it to hang, make sure it's secured
before dropping it.
2
1
Remove the battery holder and insert 4x AA batteries into the battery
compartment, noting the polarity on the battery holder. Slide back into
place and replace the glass fascia. The LEDs will Illuminate, indicating
that the ush plate is ready to be used.
Installation
1. Cut the protective casing of the in-wall cistern in-line with the
nished wall surface.
2. Screw the xing arms (supplied in the box) onto the cistern.
The rods may need cutting down depending on the thickness of the
nished wall/surface.
Battery
Holder
Good quality Alkaline batteries will last for approximately one year in
normal domestic conditions.
Once batteries are due to be replaced, a continuous alarm will be heard
for 10s, indicating that battery power is low and that they are due to be
changed. The LED lights will also ash.
Batteries are totally exhausted when the LED lights are continuously
ashing (twice per second). Please replace the batteries immediately.
A manual over-ride button is available if batteries are totally exhausted.
3. Remove the front fascia panel completely. Push the glass front to the
top and tilt the top towards you. Un-clip the glass fascia by expanding
the clip links and keep aside until installation is completed. Remove
the battery holder also to avoid damage.
Fixing Arms
2
1
Clip links
TR9016
minimum
15.5mm