Interceptor Hepa Filter Set Up Instructions - Injectidry Systems INTERCEPTOR HEPA Operation Manual

INTERCEPTOR HEPA FILTER - SET UP INSTRUCTIONS
STEP 1: Install the Interceptor Air IN Main hose
onto the Interceptor HEPA filter. Each hose is
labeled with an AIR IN and AIR OUT label. This
can get a little confusing, so we recommend fol-
lowing these steps to ensure it is placed in the
right order.
The AIR IN hose has a 2" hosecuff and 2" female
pipe threaded fitting.
The AIR OUT hose has a 2" hosecuff and 2" male
pipe threaded fitting.
800.257.0797
STEP 2: Remove and set aside the Main W
from the end of the Main Air IN hose from
either the HP unit.
You can go ahead and thread the Main W on
the end of the Interceptor Main AIR IN hose
(if using a WS first, see page 6).
STEP 3: Install the AIR IN hose onto the side
of the Interceptor labeled as AIR IN (also
same side where the Interceptor label is in-
stalled).
4 www.injectidry.com