Step 6: Damping Rings And Drive Belt; Step 7: Connect Motor To Electric Supply; Care And Maintenance - NOTTINGHAM ANALOGUE STUDIO INTERSPACE JUNIOR Setup Instructions

STEP 6:- PUT THE TWO DAMPING RINGS AROUND THE TOP TWO GROOVES OF THE PLATTER. ADD THE
DRIVE BELT AND ALIGN THE DRIVE BELT GROOVES OF THE PULLEY WITH THOSE OF THE
PLATTER. THE MOTOR UNIT SLIDES UP AND DOWN WITHIN THE BASE PLINTH TO ALLOW
FOR THIS. DO NOT PRESS ON PULLEY TO MAKE THESE ADJUSTMENS ONLY USE THE
OUTER OF THE MOTOR UNIT AS MOTOR SPINDLE DAMAGE MAY OCCUR.
DRIVE BELT TOP GROOVE 45RPM LOWER 33.3RPM
STEP 7:- CONNECT THE MOTOR TO THE ELECTRIC SUPPLY. YOU WILL FEEL A SLIGHT VIBRATION
THROUGH THE PULLEY, THIS IS NORMAL. TO START YOUR TURNTABLE PUSH THE
PLATTER CLOCKWISE WITH YOUR HAND, IF PUSHED TOO GENTLY THE PLATTER WILL NOT
MAINTAIN SPEED, IF PUSHED TOO HARD THE PLATTER WILL ADJUST TO THE CORRECT
SPEED IN A FEW SECONDS. TO STOP PLATTER GENTLY PLACE HAND ON THE SIDE OF
PLATTER.
YOU SHOULD NOW BE READY TO ENJOY MANY HAPPY HOURS OF LISTENING TO YOUR RECORDS.
CARE AND MAINTENANCE OF YOUR SPACEDECK TURNTABLE
- DURING THE FIRST HOURS OF RUNNING, YOUR SPINDLE AND BEARING WILL BED IN
- WE RECOMMEND AN OIL CHANGE EVERY 2 YEARS. SIMPLY LIFT PLATTER FROM BEARING
CLEAN OIL OFF SPINDLE. USE TISSUE PAPER TO REMOVE OLD OIL FROM BEARING. THEN
REPEAT STEPS 3 AND 4
- PERIODICALLY WASH THE DRIVE BELT AND DAMPING RINGS. USE WARM SOAPY WATER AND
AIR DRY.
- LINT FREE CLOTH IS BEST FOR CLEANING YOUR TURNTABLE. AVOID USING POLISH. A SIMPLE
DUST IS BEST. YOU MAY WISH TO COVER YOUR TURNTABLE WITH A PIECE OF MATERIAL WHEN
NOT IN USE.
- TURNTABLE MOTOR CAN BE LEFT SWITCHED ON WHEN NOT IN USE, HOWEVER, DO NOT LEAVE
PLATTER SPINNING CONTINUALLY WHEN NOT IN USE.
- REPLACE DUST COVER BACK ON PLATTER WHEN NOT IN USE.
- CLEAN THE STYLUS BACK TO FRONT WITH METHYLATED SPIRITS AND SMALL BRUSH.
- SHOULD YOU WISH TO EARTH THE BEARING OF YOUR TURNTABLE, PROVISION FOR A 4ML
CONNECTOR IS AVALIABLE TO THE REAR OF ALUMINIUM BEARING HOUSING (CONNECTOR AND
LEAD NOT SUPPLIED)
ANY QUESTIONS CONTACT YOUR NOTTINGHAM ANALOGUE DEALER.
MOTOR
PHOTO 1
ADJUSTABLE FEET X4
ARMMOUNT COLLET
(PHOTO 6)
PHOTO 2
PULLEY PUSH ON CENTRALLY