Related Manuals for cascade corporation QFM 35E
Summary of Contents for cascade corporation QFM 35E
- Page 1 PERATOR'S GUIDE QFM, ™ Push/Pull and Load Push No. 684945-R4 EN cascade corporation Cascade is a registered Trademark of Cascade Corporation...
-
Page 2: Table Of Contents
OntEntS Introduction WARNING: Rated capacity of the truck/ Safety Rules attachment combination is a responsibility Daily Inspection of the original truck manufacturer and may be less than shown on the attachment Attachment Operation nameplate. Consult the truck nameplate. Slipsheet Loads Loads with Torn Slipsheet Tabs WARNING: Do not operate this attachment Loading unless you are a traned and authorzed... -
Page 3: Safety Rules
afEty rulES No rders No reach through mast No underload PP0125.eps Wth load Tlt Rase 3in. No load RAMPS Motor off, park, lower load Travelng No park on ramp No turn on ramp Watch clearance PP0383.eps TRaffIC STOP Observe Workers Stops Slow for Sound horn, Sound horn, Wet floors Bumps Dps two way slow at slow at traffic ntersecton corner 684945-R4 EN... -
Page 4: Daily Inspection
aily inSPEctiOn Check items each day. Report problems to your supervisor. See Service Manual 686455 for maintenance and repair procedures. Leaks Fasteners Ncks and burrs Mountng engagement PP0127.eps ttachmEnt OPEratiOn SolENoID EquIPPED aTTaChmENTS PuSh/Pull wITh ShEET-SaV A Sideshift left PuSh/Pull B Sideshift right loaD PuSh PuSh/Pull wITh SIDEShIfT C Faceplate push... -
Page 5: Slipsheet Loads
liPShEEt lOadS Nonskd coatng recommended Transport Stack behnd fold n. Bandng OR Stretchwrap PP0129.eps Tlt Untzed loads loads with Torn Slipsheet Tab Wall 3-4° second load Tlt Wedge both tps under slpsheet. Drve forward. Poston load 6 n. over new slpsheet. Lower platen onto slpsheet. Push off load. n. Poston 1/4 n. behnd fold. PP0130.eps Rase platen. Drve n reverse 684945-R4 EN... -
Page 6: Loading
OadinG frOm flOOr Square tps to load Tlt Sheet tab n grpper 3-4° Tlt PP0131.eps Pull load OPTIONAL: Pull and drve forward OadinG frOm PallEtS Tlt 3-4° Sheet tab n grpper Tlt Pull Load. OPTIONAL: Pull and drve forward PP0132.eps 1 n. Rase platens 1 n. above pallet 684945-R4 EN... -
Page 7: Loading From Stacks
OadinG frOm StackS Tlt 3-4° Square tps to load Lower and Sheet tab n grpper tlt Pull load OPTIONAL: Pull and drve forward. Platen tp just below tab PP0133.eps Rase platens as load s pulled on. OadinG frOm truck trailErS CauTIoN: level trailer with dock. watch for nails or screws on trailer floor and walls. 3-4° Tlt Sheet tab n grpper Dockplate requred Pull load OPTIONAL: Pull and drve forward CAUTION: Traler wheels must be locked... -
Page 8: Unloading
nlOadinG On StackS Poston load 6 n. from load edge, 1/2 n. above load. 6 n. Drve n reverse and lower Tlt slghtly as load s pushed 1-2° n. Lower and tlt PP0135.eps Match load corners nlOadinG On PallEtS Pallet Boards in line with Push Direction Poston load 6 n. over pallet. Tlt Lower platen onto pallet. 3-4° Push load to pallet edge PP0136.eps Drve n reverse as load s pushed Rase platen slghtly 684945-R4 EN... -
Page 9: Unloading On Pallets
nlOadinG On PallEtS Pallet Boards opposite Push Direction Poston load 4 n. from pallet edge, Tlt 4 n. 1/2 n. above pallet 3-4° n. Drve n reverse Push load to pallet edge as load s pushed PP0137.eps nlOadinG intO truck trailErS CauTIoN: level trailer with dock. watch for nails or screws on trailer floor and walls. Poston 12 n. from Tlt forward load Sdeshft aganst wall Dockplate 3-4°... -
Page 10: Sheet-Sav ® Operation
hEEt-SaV OPEratiOn Rase Sheet-Sav foot. Pull load Sheet tab postons OPTIONAL: Pull and drve forward under foot Press Knob Button to Push-Pull Sheet-Sav Lower Sheet-Sav foot. PP0139.eps ttachmEnt rEmOVal qfm™ (quick fork mount) attachments Extend faceplate and rase ¾ 2 ft. Turn down lower hooks Quck dsconnect Back away couplers PP0140.eps 684945-R4 EN... -
Page 11: Attachment Installation - Qfm
ttachmEnt inStallatiOn qfm™ (quick fork mount) attachments Adjust forks Engage 20.5- upper hooks 25.5 in. Attachment on center A Drve forks under attachment B Engage upper forks A Turn up lower hooks B Adjust hook clearance and tghten Quck dsconnect couplers 1/16 n. 55-65 ft.-lbs. PP0141.eps latEn adjuStmEnt Dedicated attachments qfm (quick fork mount) attachments 35-45 ft.-lbs. PP0142.eps 4 n. 10 n. 684945-R4 EN... -
Page 12: Faceplate Stop Adjustment
acEPlatE StOP adjuStmEnt attachments equipped with faceplate stop option Pull out to adjust PP1248.eps PP1249.eps 38 in. Maxmum Settng 684945-R4 EN... -
Page 13: Safe Operation And Maintenance
afE OPEratiOn and maintEnancE Industrial Trucks and attachments A load backrest extension shall be used whenever necessary WARNING: When operating and maintaining to minimize the possibility of the load or part of it from falling industrial trucks equipped with attachments you rearward. - Page 14 Pte. Ltd. Rocklea, QLD 4107 East Tamaki, Auckland 18 Tuas South Street 5 Australia New Zealand Singapore 637796 Tel: +65-6795-7555 Tel: 1-800-227-223 Tel: +64-9-273-9136 Fax: +61 7 3373-7333 Fax: +64-9-273-9137 Fax: +65-6863-1368 Cascade Corporation 2007 9-2007 Part No. 684945-R4 EN...
Need help?
Do you have a question about the QFM 35E and is the answer not in the manual?
Questions and answers