Download Print this page

Bendcart BC-100 Assembly Instructions

Remove all Cardboard

Review drawing on page 3 and 4 of instruction pack.

Pump Tray

Mount the pump tray by lowering the long bar down into the pump tray support

tube on the back of the Bendcart

Mount Bender Supports (2)

-remove the 3/8" bolts and spacers

-slide the bender supports over the frame top and cross member with the

support pins pointing away from the saddle and shoe storage posts

-reinstall spacers and bolts

-tighten bolts

Mount Conduit Holdown wheel

- raise the follow bar support above the level of the rear wheels by turning the

adjustment handle

-remove the cotter pin and washer from the follow bar support tube

-slide the conduit holdown wheel assembly onto the follow bar support tube

and reinstall the washer and cotter pin. Bend the ears of pin to secure.

Bendcart BC-100 assembly instructions

Table of Contents

Need help?

Do you have a question about the BC-100 and is the answer not in the manual?

Page 1 Review drawing on page 3 and 4 of instruction pack. Pump Tray Mount the pump tray by lowering the long bar down into the pump tray support tube on the back of the Bendcart Mount Bender Supports (2) -remove the 3/8” bolts and spacers...
Page 2 -Slide the second side bar onto the bender support pins -Install the 2 hairpins into the proper holes to secure the bender to the Bendcart. (NOTE: the 881 bender uses the outer holes, the 885T uses the inner set of holes)
Page 3 If the conduit is not properly aligned there is a possibility of the saddle pin getting caught under the Bendcart crossbar when making 90 deg bends. This is more of a problem on smaller conduits as the pin can extend thru the saddle several inches.
Page 4 pg 3...
Page 5 pg. 4...