1. Manuals
  2. Brands
  3. Inter-fab Manuals
  4. Play Sets & Playground Equipment
  5. X-STREAM 2 SLIDE
  6. Assembly/installation instructions

Inter-fab X-STREAM 2 SLIDE Assembly/Installation Instructions

Hide thumbs Also See for X-STREAM 2 SLIDE:
Table of Contents

Advertisement

Quick Links

Download this manual
X - S T R E A M 2
S L I D E
™
Assembly & Installation Instructions
IMPORTANT
THESE INSTRUCTIONS
MUST REMAIN WITH
THE SLIDE OWNER!
3 0 5 0
S .
A L V E R N O N
W A Y
•
T U C S O N ,
A Z
8 5 7 1 3
5 2 0 . 7 9 0 . 7 0 4 0
•
8 0 0 . 7 3 7 . 5 3 8 6
•
F A X
5 2 0 . 7 9 0 . 7 1 2 7
i n t e r f a b . c o m
XS2-IM Rev. 10/14 (SBK-XS2 INSTALL)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the X-STREAM 2 SLIDE and is the answer not in the manual?

Questions and answers

Related Manuals for Inter-fab X-STREAM 2 SLIDE

Summary of Contents for Inter-fab X-STREAM 2 SLIDE

  • Page 1 X - S T R E A M 2 S L I D E ™ Assembly & Installation Instructions IMPORTANT THESE INSTRUCTIONS MUST REMAIN WITH THE SLIDE OWNER! 3 0 5 0 A L V E R N O N W A Y •...

  • Page 3: Table Of Contents

    Step 9: Connect Water Supply System ........15 Step 10: Finishing Steps............16 Final Inspection Check List .............16 Slide Care & Maintenance............16 Paver Kit Information.............17 Exploded View of X-Stream 2 Slide ..........18 Parts List (corresponds with exploded view)......19 Hardware Kit Information ............20 Notes..................21 Inter-Fab Limited Warranty.............22...

  • Page 4: Important Notices To The Installer

    X - S T R E A M 2 ™ S L I D E IMPORTANT NOTICES TO THE INSTALLER THE X-STREAM 2 SLIDE CAN BE ASSEMBLED AND INSTALLED IN EITHER A LEFT OR RIGHT TURN CONFIGURATION. INTER-FAB HIGHLY RECOMMENDS THAT YOU READ THE ENTIRE INSTALLATION MANUAL BEFORE YOU ATTEMPT THE INSTALLATION OF THE X-STREAM 2 SLIDE.

  • Page 5: Intended Use Instructions

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E INTENDED USE INSTRUCTIONS Everyone who uses this slide must know, understand and follow these instructions The ANSI/APSP/ICC-5 2011 standard for above ground pools prohibits the use of slides or diving boards on above ground pools.

  • Page 6: Water Safety Envelope

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E X-STREAM 2 WATER SAFETY ENVELOPE: DIAGRAM A A minimum water depth of three feet (3') under the exit (NOT TO SCALE) of the slide which increases to a depth of four feet (4')

  • Page 7: Slide Placement & Footprint Diagrams - Left Turn

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E SLIDE PLACEMENT DIAGRAM & FOOTPRINT DIAGRAM X-Stream 2 Slide - Left Turn DIAGRAM D (NOT TO SCALE)

  • Page 8: Slide Placement & Footprint Diagrams - Right Turn

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E SLIDE PLACEMENT DIAGRAM & FOOTPRINT DIAGRAM X-Stream 2 Slide - Right Turn DIAGRAM F (NOT TO SCALE)

  • Page 9: Slide Components

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E X-STREAM 2 SLIDE COMPONENTS IMPORTANT: For a Left Turn Slide, Flume A–B is upper flume, and C–D is the lower flume, in that order.

  • Page 10: Required Tools

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E LIST OF REQUIRED TOOLS Tools required for assembly and installation of X-Stream 2 slide: NOTE: USE PROVIDED ANTI-SEIZE ON ALL BOLTS! Hammer 3/8"...

  • Page 11: Step 1: Attach Step Assembly To Entry Section

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP ONE: ttach the Step ssembly to the Entry Section Thread the flex PVC hose from the entry section through the step tube assembly and out the pre-drilled hole above the bottom step.
  • Page 12 I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP TWO: ttach the Handrails to the Ladder and Entry Section - CONT. Insert the correct length of all-thread into the nuts embedded in the handrails then attach the handrails as illustrated.
  • Page 13 I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP TWO: ttach the Handrails to the Ladder and Entry Section - CONT. Fig.

  • Page 14: Step 3: Attach Feet To Legs

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP THREE: ttach the Foot Pedestals to the Legs TIP: Both PVC legs have a different hole drill pattern at each end.

  • Page 15: Step 4: Assemble The Flume Sections

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP FOUR: ssemble the Flume Sections – CONT. Utilizing hardware kit XS2-102-SS, attach the exit section to the lower flume section.

  • Page 16: Step 7: Attach Entry Section & Ladder To Flume

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP SEVEN: ttach the Entry Section & Ladder to the Flume Utilizing hardware kit XS2-102-SS, thread the (5) 3/8”...

  • Page 17: Step 8: Anchor Slide To Deck

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP EIGHT: nchoring the Slide to the Deck Position the assembled slide on the deck in its correct and final position, then ensure that the long and short legs are plumb by checking each leg with a bubble level on two sides at 90˚...

  • Page 18: Step 10: Finishing Steps

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E STEP TEN: Finishing Steps • Install protective caps on all exposed bolts. •...

  • Page 19: Paver Kit Information

    X - S T R E A M 2 ™ S L I D E PAVER KIT INFO – X-STREAM 2 When installing an Inter-Fab X-Stream™ 2 or G-Force™ 2 slide using a paver kit, you must ensure that all standard installation requirements are met. The slide must be compatible with the type of pool on the intended installation and all ANSI/APSP/ICC-5 2011 requirements must be met.

  • Page 20: Exploded View Of X-Stream 2 Slide

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E X-STREAM 2™ SLIDE (XS-GR-SS) XS2-IM Rev. 10/14 (SBK-XS2 INSTALL)

  • Page 21: Parts List (Corresponds With Exploded View)

    * not pictured HARDWARE NOTE: Use a small dab of NOTES: anti seize lubricant X-Stream 2 slide only comes in Summit Gray (included) on all bolt X-Stream 2 can turn to the right or the left threads. XS2-IM Rev. 10/14 (SBK-XS2 INSTALL)

  • Page 22: Hardware Kit Information

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E X-STREAM 2™ SLIDE HARDWARE KITS XS-101-SS – PVC LEG TO FOOT RECEIVER QTY P RT NUMBER COMPONENT DESCRIPTION H-SS 3/8-16X2...

  • Page 23: Notes

    I N S T A L L A T I O N M A N U A L X - S T R E A M 2 ™ S L I D E NOTES: XS2-IM Rev. 10/14 (SBK-XS2 INSTALL)

  • Page 24: Inter-Fab Limited Warranty

    Inter-Fab, Inc., and expressly does not cover any labor or reinstallation expenses related to the replacement of any and all Inter-Fab products. This limited warranty shall be the sole and exclusive remedy of irrespective of whether the claims are made in contract, tort, warranty, law, equity or by statue.

Table of Contents