Data Forwarding; Ethernet Characteristics - Nokia FastMile 4G Product Overview

Functional overview
•
•
Table 3
E-UTRA bands
Band 42/43/48 (mono-band support)
Band 42/43/48 (ABA support)
Band 3 (mono-band support)
Band 7/38/40/41 (mono-band support)
Band B3/B7/B20/B32 (multi-band support)
Band B1/B3/B7/B38/B40/B41/B20/B28 (multi-band support)

6.3 Data forwarding

The Nokia FastMile 4G Receiver supports the following data forwarding methods:
Table 4
Forwarding mode
Single APN with multi-bearers
for route mode
Single APN with multi-bearers
for bridge mode
Multiple APNs with bridge
mode
Multiple APNs with mixed
mode
Tunnel mode

6.4 Ethernet characteristics

The following are some of the key Ethernet characteristics of the Nokia FastMile 4G
Receiver:
•
•
40
LTE 3GPP Release 12 Compliant, UE Category 12
supports the E-UTRA bands listed in Table
E-UTRA bands supported by the Nokia FastMile 4G Receiver
Data forwarding methods supported by the Nokia FastMile 4G
Receiver
provides a 1 Gbps Ethernet LAN Interface that, depending on the model of the
Nokia FastMile 4G Receiver, has the following:
the Compact mono-band and ABA models have a pre-attached 3 m (9.8 ft) Cat5e
shielded twisted pair Ethernet cable with a male RJ 45 connector at the free end
the Compact multi-band and models have a female RJ 45 connector that supports
3TG-00386-ABAA-TCZZA
Nokia FastMile 4G Receiver Product Overview
3
Typical use
Recommended for using only one APN specific for Nokia FastMile 4G
Receiver
Could be used for WAN of IDU with VLAN tag
Used as multi-APN, separated service with APNs: each APN is for each
service.
Note in this case, a specific port should be reserved for service traffic.
Can be used for separated APNs on OAM and also other APNs for
separated services:
•
Only default APN is in route mode which could be OAM
•
Besides APN, each APN is for each service
Can be used for using tunnel for L2 forwarding such as PPPoE
DRAFT
Model
4G01-A
4G01-B
4G02-A
4G03-A
4G04-A
4G05-A
Issue: 01 DRAFT
•