Contents Overview ..................3 Use ....................4 Device parts ..................6 About this user manual ..............9 Proper use ..................12 Safety information .................13 Package contents ................20 Mounting on the wall ..............21 Operation ..................22 Description of the charging cycle ..........29 Protection against wrong polarity ..........31 Overheating cut-out ..............
Device parts Device parts M O D E button Display Fixing holes Mains cable with mains plug Connection cable with ring terminals Negative terminal clamp (black), with connection cable Fixing screws Positive terminal clamp (red), with connection cable 12 V / 0.8 A charging mode active – standard charging 12 V / 0.8 A / COLD charging mode active –...
Page 7
Contents Contents Overview ......................3 Use ........................4 Device parts ..................... 6 About this user manual ................... 9 Explanation of symbols ..................9 Proper use ...................... 12 Safety information ..................13 Setting up the appliance .................. 16 Charging process....................17 Handling rechargeable batteries ..............18 Package contents ..................
Page 8
Contents EU Declaration of conformity ................ 36 Service information ..................37 Legal Notice ....................38 Privacy statement ..................39...
About this user manual About this user manual Thank you for choosing our product. We hope you enjoy using this appliance. Read the safety instructions carefully before using the appliance for the fi rst time. Note the warnings on the appliance and in the user manual. Always keep the user manual close to hand.
Page 10
About this user manual Additional information on using the appliance! Read the user manual and observe its instructions. Protection class II Electrical appliances in protection class II are electrical appliances that permanently have double and/or reinforced insulation and do not have any connection options for a protective earth.
Page 11
About this user manual Declaration of conformity Products that feature this symbol meet the requirements of the EC directives (see section ‘Declaration of conformity’)
Proper use Proper use This appliance is a primary-side switched charging appliance with pulse trickle charging. It is suitable for charging and trickle- charging the following rechargeable 6 V or 12 V lead batteries containing an electrolyte solution or gel as well as AGM batteries, which are used in motor vehicles: –...
Safety information • Only use replacement parts or accessories that we have supplied or approved. • Comply with all the information in this user manual, especially the safety information. Any other use is considered improper and can cause personal injury or property damage. •...
Page 14
Safety information − This appliance may be used by children over the age of 8 and by persons with reduced physical, sensory or mental abilities or by those with limited experience and/or knowledge, provided that they are supervised or have been instructed in the safe use of the appliance and have understood the associated risks.
Page 15
Safety information − Do not use if the appliance or the mains cable is visibly damaged or if the appliance has been dropped. − Appliances connected to the mains during a thunderstorm may be damaged by power surges. You should therefore always unplug the plug during thundery conditions.
Safety information The appliance must not be immersed in water or other liquids, or held under running water, because this could cause an electric shock. − Unplug the appliance from the socket if: – you are cleaning the appliance, – the appliance is damp or wet, –...
Safety information − Do not cover the charger, otherwise it may overheat and become damaged. Charging process WARNING! Risk of explosion! Improper handling of the charger can result in sparks and trigger an explosion. Gaseous hydrogen may fl ow out of the battery during charging and trickle charging.
Safety information − Avoid the creation of sparks when connecting and disconnecting the charger: – Avoid an electrical short circuit when connecting the charger to the battery. Always connect the negative terminal connection cable (black) to the battery’s negative terminal. Always connect the positive terminal connection cable (red) to the battery's positive terminal.
Page 19
Safety information − Remove the leaking battery liquid with a dry, absorbent cloth and avoid contact with skin, for example, by using acid-proof protective gloves. General information − Do not use the charging and trickle charging process on batteries that cannot be recharged. −...
Package contents Package contents DANGER! Risk of choking and suffocation! There is a risk of choking and suffocation due to swallowing or inhaling small parts or plastic wrap. − Keep the plastic packaging out of the reach of children. − Do not let children play with the packaging material. −...
Mounting on the wall Mounting on the wall The appliance has fi xing holes so that you can attach it to the wall. WARNING! Risk of electric shock! There is a risk of electric shock from live parts of the appliance. −...
Operation Operation − Remove the product from the packaging and remove all the packaging material and the protective fi lm on the display. Connecting the charger to the battery The charger will automatically recognise the battery type connected (6 V or 12 V battery).
Operation You can unscrew the terminal clamps on the battery charger to securely connect it to the battery with the ring terminals, for example, for trickle charging in winter. Select charging mode Select a charging mode depending on the battery type and ambient temperature. You can also recharge a completely discharged battery (Page 29).
Page 24
Operation Modus 6 V / 0.8 A standard charging mode: Charging a 6 V battery Recommended battery capacity 1.2–14 Ah, 0.8 A charging current 12 V / 0.8 A standard charging mode: Charging a 12 V motorcycle battery or 12 V car battery Recommended battery capacity 1.2–120 Ah, 0.8 A charging current 12 V / 0.8 A / COLD standard charging mode: Charging process for a 12 V motorcycle battery or 12 V car battery at low...
Page 25
Operation Charging Final charge Suitable for Display Battery current voltage battery type Attention! Charging lithium batteries is Observe the battery prohibited! manufacturer's charging recommendations. 1.2 Ah–120 Ah DC 12 V motorcycle 0.8 A 14.3 V Lead acid; lead; and DC 12 V car AGM, GEL; EFB; wet 1.2 Ah–120 Ah DC 12 V motorcycle 0.8 A...
Operation 6 V / 0.8 A charging mode (6 V batteries up to max. 14 Ah) You can identify the battery type from the type plate on your battery. Observe the battery charging recommendations. The charger will normally recognise the 6 V standard charging mode suitable for the battery type.
Operation 12 V / 0.8 A charging mode (12 V batteries up to max. 120 Ah, at low temperatures) You can identify the battery type from the type plate on your battery. Observe the battery charging recommendations. The charger will normally recognise the 12 V standard charging mode suitable for the battery type.
Operation 12 V / 5 A charging mode (rapid charging for 12 V batteries from 1.2 Ah to 120 Ah) You can identify the battery type from the type plate on your battery. Observe the battery charging recommendations. Proceed as follows: − Set this mode to charge batteries with a capacity of 1.2 Ah and over and normal ambient temperatures.
Description of the charging cycle Regenerating/recharging fully discharged 12 V batteries (regeneration mode) − Connect the fully discharged battery to the charger and start the charging process. In this regeneration mode, the battery is charged until the charger measures a terminal voltage that is high enough for a regular charging mode. The appliance then switches automatically to an appropriate charging mode and continues charging.
Page 30
Description of the charging cycle Charging mode Charging step Battery voltage Continuation of the At a battery voltage of < 12.8 V, the charging process charging process continues with a charging current of 0.8 A. 12 V / 5 A Impulse charging At a battery voltage from 7.5 to 10.5 V, (reactivation of the the charging process takes place...
Protection against wrong polarity Charging mode Charging step Battery voltage 12 V / 5 A / Continuous charging At a battery voltage of 14.1 V to 14.8 V, COLD the charging process continues with a charging current of 3.0 A. At a battery voltage of 14.8 V to 15.5 V, the charging process continues with a charging current of 0.8 A.
Overheating cut-out Overheating cut-out If the appliance temperature exceeds 115°C, the overheating cut-out is triggered, and the charging process is interrupted until the appliance has cooled off. The display continues to show the charge level. Disconnecting the battery WARNING! Risk of explosion! Improper handling of the charger can result in sparks and trigger an explosion.
Cleaning and care Cleaning and care WARNING! Risk of electric shock! There is a risk of electric shock from live parts of the appliance. − Before assembly and maintenance work and before cleaning the appliance, always unplug the mains plug from the mains power supply.
Disposal Disposal PACKAGING The product has been packaged to protect it from damage TRAY FILM in transit. The packaging is made of materials that can be Don’t Recycle Recycle recycled in an environmentally friendly manner. Recycle DEVICE All old appliances marked with the symbol illustrated must not be disposed of in normal household waste.
Technical specifi cations Technical specifi cations Model MD 19787 Input 220–240 V ~ 50 Hz, 0.8 A Output during standby < 0.8 W Electrical protection class Voltage tolerance ± 0.3 V Current tolerance ± 10% (± 15% for 0.8 A) Trickle charge current 50–150 mA Cut-off voltage approx.
EU Declaration of conformity EU Declaration of conformity MEDION AG hereby declares that this product conforms with the essential requirements and the remaining relevant regulations: • EMC Directive 2014/30/EU • Low Voltage Directive 2014/35/EU • Ecodesign Directive 2009/125/EC (and Ecodesign Regulation 2019/1782) •...
Service information Service information Please contact our Customer Service team if your device ever stops working the way you want or expect it to. There are several ways for you to contact us: • In our Service Community, you can meet other users, as well as our staff, and you can exchange your experiences and pass on your knowledge there.
Privacy statement Privacy statement Dear customer, We wish to inform you that we, MEDION AG, Am Zehnthof 77, 45307 Essen, Germany process your personal data as a data controller. For matters regarding data protection, we are supported by our company data protection offi...
Page 41
PRODUCED IN CHINA FOR: ALDI STORES LTD. PO BOX 26, ATHERSTONE WARWICKSHIRE, CV9 2SH. ALDI STORES (IRELAND) LTD.
Need help?
Do you have a question about the AUTOXS MD 19787 and is the answer not in the manual?
Questions and answers
Will the auto xs 19787 charge a litihium battery
No, the ALDI AUTOXS MD 19787 does not charge lithium batteries. The manual explicitly states that charging lithium batteries is prohibited.
This answer is automatically generated