Advertisement
Step 5
Close tent zip
starting top right as shown.
Step 6
Close tent zip top to bottom as shown.
Fit equipment hanger ends to poles.
Position equipment hangers as required.
Equipment
Hanger End
Assembly Instructions
Two Person Assembly
Mammoth
Classic 200, 240, 300
Assembly Guide
Equipment Hangers
Lower Equipment Hanger
Parts List
Yellow Pole
Blue Pole
Black Pole
x28
x9
x9
Equipment
Support Pole
Hanger Ends
Rubber Foot
x16
x1
Straight Pole Connectors x2
Upper Equipment Hanger
3-Way
4-Way
Corner
Join
x8
x8
Support Pole
Rubber Top
x1
Centre Securing Ring x1
Advertisement
Table of Contents
Related Manuals for Mammoth Tents Classic+ 200
Summary of Contents for Mammoth Tents Classic+ 200
- Page 1 Assembly Instructions Step 5 Two Person Assembly Close tent zip starting top right as shown. Mammoth Classic 200, 240, 300 Assembly Guide Equipment Hangers Upper Equipment Hanger Lower Equipment Hanger Step 6 Parts List Close tent zip top to bottom as shown. Fit equipment hanger ends to poles.
- Page 2 Step 1 Step 3 Insert ceiling poles into 3-way corners and 4-Way joins. Organise poles and connectors into their colours and groups. Fit centre securing ring over pole before fitting to 4-way join. Unzip and lay out tent. Fit centre ceiling poles into straight pole connectors. Locate floor section and lay flat with edge sections vertical.
Need help?
Do you have a question about the Classic+ 200 and is the answer not in the manual?
Questions and answers