Exiting The User Program - GE DigitalFlow DF868 Startup Manual

2.7 Exiting the User Program

After the calibration factor entry has been made, the meter will exit the
Program screen.
At the conclusion of the initial setup programming sequence, the following screen appears:
Note: If you press
[NO]
instructions on using the
Proceed to Chapter 3, Operation, for instructions on taking measurements or refer to the Programming Manual for
instructions on programming the Model DF868's advanced features.
DigitalFlow™ Multipurpose Ultrasonic Liquid Flowmeter Startup Guide (1- and 2-Channel)
PROGRAM
PROGRAM
status
ACTIV SYSTM PIPE
PROGRAM
Do you want to SAVE
current selection appears here
No Yes
, the DF868 still retains the newly programmed information. See the Programming Manual for
SAVE
submenu.
PIPE
Start ‰ To leave the
User Program
begin taking measurements,
[EXIT]
press .
I/O
Start At the
User Program
shown, press
measurement mode without
saving the file or press
SAVE
enter the
submenu and return to the initial User
and
screen
[F1]
to return to
[F2]
to
submenu.
Chapter 2. Initial Setup
29