Table of Contents
Advertisement
Available languages
Available languages
Control / Visualisation
Restart Cleaning Module:
To restart the cleaning module, press keys 1,2 and 4 for seven seconds.
4.5.1
Alarm - Water valve
If the mixing container will be filled at beverage mode, a slashed faucet symbol is
displayed and the display will flash between green and blue.
If there is a active fault message a further slashed faucet is displayed the display will flash
between red and blue.
Fig. 26: Alarm - Water valve
4.5.2
Alarm - Alarm - Error: Compressor
Fig. 27: Alarm level - ERROR: Compressor
1
Current consumption to high at start.
2
Compressor runs continuously for 15 min.
3
Compressor running time higher than 75 % in one hour.
Ä Chapter 6.2.1 'Display error messages and incidents' on page 32, Fig. 33.
See
4.5.3
Alarm - No Cleaning
If the 'Beer Cut' time is exceeded, an alarm is displayed and the 'Beer Cut' activated.
Cleaning must be carried out.
Fig. 28: Alarm level - No Cleaning for 21 days
Rev. 04-06.2018
28
- Quick Links:
- Alarm - Alarm - Error: Compressor
Hide quick links:
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the DM Modular 20 and is the answer not in the manual?
Questions and answers
Ho ritardato la pulizia ed è diventato rosso come posso farlo ripartire
To restart the Ecolab DM Modular 20 after delaying cleaning and it has turned red, you need to execute the cleaning program. If the "Beer Cut" function has been activated, the system will not operate until cleaning is performed. Follow these steps:
1. Start the cleaning program as indicated in the system menu.
2. If cleaning cannot be performed immediately, you may delay it by one day (+1) once.
3. If the system remains in a locked state, execute the cleaning process to reset the alert.
If the issue persists, refer to the maintenance instructions or seek technical support.
This answer is automatically generated