Operation - Batavia FLIPOUT BT-TS001 Operating Instructions Manual

• Do not store in locations where the tem-
perature may exceed 40 °C.
• Charge only at ambient temperatures
between 10 °C and 40 °C.
• Charge only using the charger provided
with the appliance/tool.
• When disposing of batteries, follow the
instructions given in the section
"Disposal".
• Do not damage/deform the battery pack
either by puncture or impact, as this may
create a risk of injury and fire.
• Do not charge damaged batteries.
• Take special care of the battery. Avoid
dropping it onto any hard surface and do
not subject it to pressure or any other form
of mechanical stress. Keep the battery
away from extreme heat and cold.
• Important Danger! Never short-circuit the
battery or expose it to moisture. Do not
store it together with any metal parts
which could short-circuit the contacts.
The battery could overheat, start burning
or explode.
Under extreme conditions, battery leakage
may occur. When you notice liquid on the
batteries, proceed as follows: Carefully wipe
the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the
instructions below.
Warning!
The battery fluid may cause personal injury or
damage to property.
In case of skin contact, immediately rinse with
water. If redness, pain or irritation occurs seek
medical attention. In case of eye contact, rinse
immediately with clean water and seek medical
attention.
Chargers
Your charger has been designed for a specific
voltage. Always check that the mains voltage
corresponds to the voltage on the rating plate.
Warning!
• When not in use and before cleaning and
servicing, disconnect the battery charger
from the power supply.
• Never attempt to replace the charger unit
with a regular mains plug.
• Use your charger only to charge the bat-
tery in the appliance/tool with which it was
7062267_FlipOut_Ma_#1605-04.indb 13
supplied. Other batteries could burst,
causing personal injury and damage.
• Never attempt to charge non-rechargeable
batteries.
• If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorized Service Centre in order to avoid
a hazard.
• Do not expose the charger to water.
• Do not open the charger.
• Do not probe the charger.
• The appliance/tool/battery must be placed
in a well ventilated area when charging.

OPERATION

Operation of Lithium-Ion Batteries
Lithium-ion batteries share many characteris-
tics with conventional batteries.
The major difference is that Lithium-ion batter-
ies do not have a "memory" and do not require
to be completely discharged periodically. It is
recommended to charge Lithium-ion batteries
after each use so they will be fully charged
when needed.
Lithium-ion batteries perform best and deliver
peak output power at room temperature.
When operated in lower temperatures, the
battery output will be reduced.
NOTE: A fully charged battery will loose about
2% of its charge per month during storage.
ASSEMBLY AND OPERATION
Charging the Battery
1. Insert the charger plug into the receptacle
(4) in the side of the driver.
2. Plug the battery charger (10) into a 230 V,
50 Hz wall receptacle.
Notes:
a. Make sure the charger plug is fully
inserted into the matching receptacle at
the side of the driver handle.
b. A new battery or one that is completely
exhausted should be charged for one hour
or until the red charging indicator LED
turns OFF. After normal use, a battery
should be fully charged in one hour.
c. If the battery does not charge properly,
check to make sure the electrical outlet is
"live" and that the temperature range in the
work area is between 0–40° C.
.
English
13
06-05-16 09:33