Weber FLAME Owner's Manual
  1. Manuals
  2. Brands
  3. Weber Manuals
  4. Indoor Fireplace
  5. FLAME
  6. Owner's manual

Weber FLAME Owner's Manual

Weber owner's guide natural gas fireplace weber flame
Hide thumbs Also See for FLAME:

Advertisement

Table of Contents

WEBER
FLAME
Natural Gas Fireplace Owner's Guide
WARNING
If the information in this manual is not
followed exactly, a fi re or explosion may
result causing property damage, personal
injury or loss of life.
•
Do not store or use gasoline or other
fl ammable vapors and liquids in the
vicinity of this or any other appliance.
- WHAT TO DO IF YOU SMELL GAS:
•
Do not try to light any appliance.
•
Do not touch any electrical switch; do
not use any phone in your building.
•
Immediately call your gas supplier from
a neighbor's phone.
•
Follow the gas supplier's instructions.
•
If you cannot reach the gas supplier, call
the fi re department.
- Installation and service must be performed
by a qualifi ed installer, service agency or
the gas supplier.
TM
#39995
WARNING
Improper installation, adjustment,
alteration, service or maintenance can
cause injury or property damage. Read the
installation, operating and maintenance
instructions thoroughly before installing
or servicing this equipment.
WARNING: FOR OUTDOOR USE ONLY.
These instructions are to be retained by the
consumer for future reference.
This appliance is not a heater.
39995 US 03/16/05

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FLAME and is the answer not in the manual?

Questions and answers

Related Manuals for Weber FLAME

Summary of Contents for Weber FLAME

  • Page 1 WEBER FLAME Natural Gas Fireplace Owner’s Guide WARNING If the information in this manual is not followed exactly, a fi re or explosion may result causing property damage, personal injury or loss of life. • Do not store or use gasoline or other fl...

  • Page 2: Dangers And Warnings

    Do not use a fl ame to check for gas leaks. Combustible materials should never be within 24 inches of the top, back or sides of your Weber Do not put a fi replace cover or anything fl ammable on, or beneath the fi replace.
  • Page 3 ® ©2003 The following trademarks are registered in the name of Weber-Stephen Products Co., an Illinois corporation, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A. Australia; Smokey Joe, Weber, Kettle Silhouette Grill Confi guration, Botswana; Weber, Canada; Smokey Joe, Genesis, China; Kettle Silhouette Kettle Silhouette , Smokey Joe, Weber, One-Touch, Germany;...

  • Page 4: General Instructions

    STORAGE AND/OR NON USE • The gas must be turned off at the natrual gas supply when the Weber fi replace is not in use. • When the Weber ®...

  • Page 5: Parts List

    BASE - 1 BACK PANEL - 1 RAIN SHIELD - 3 HOOD VENT SUPPORT - 4 SUPPORT BRACKET - 3 LAVA ROCKS PARTS LIST CERAMIC LOGS - 8 HOOD VENT - 1 HOSE - 1 1/4 - 20 1/2” CARRIAGE BOLT - 16 1/4 - 20 1/2”...

  • Page 6: Exploded View

    EXPLODED VIEW...

  • Page 7: Exploded View List

    HOOD VENT 1/4 - 20 X 1/2” CARRIAGE BOLT SUPPORT BRACKET QUICK-DISCONNECT HOSE 1/4 - 20 X 1/2” NUT HOOD VENT SUPPORT RAIN SHIELD REAR PANEL WASHER 10. 1/4 - 20 X 1/2” KEPS NUT 11. GAS TRAIN ASSEMBLY 12. WHEEL COVER 13.
  • Page 8 Assembly: Consumer - 40 Minutes. *Professional - 30 Minutes. Hand tighten only. ASSEMBLY Hand tighten only. Hand tighten only.
  • Page 9 ASSEMBLY Hand tighten only. Warning text on panel faces outward.
  • Page 10 Wrench tighten ALL nuts at this time. Empty lava rocks onto cardboard packing. Remove small debris. Do not empty bag of lava rocks directly into the fi replace. Doing so could cause the burner ports to clog. ASSEMBLY Do not obstruct ignition box.
  • Page 11 Place ceramic logs in fi replace. NEVER burn real logs in fi replace. ASSEMBLY Always attach rain shields when not in use and for storage. Do not operate fi replace untill ALL rain shields have been removed. Failure to do so could result in a fi...
  • Page 12 National Fuel Gas Code: ANSI Z 223.1/NFPA 54, or CAN/CGA-B149.1. GAS INSTRUCTIONS This is a typical installation of a Weber fireplace. Local codes may require different installations.

  • Page 13: Side View

    DANGER Do not use an open fl ame to check for gas leaks. Be sure there are no sparks or open fl ames in the area while you check for gas leaks. This will result in a fi re or explosion which can cause serious bodily injury or death and damage to property.
  • Page 14 Note - All factory-made connections have been thoroughly checked for gas leaks. The burner has been fl ame-tested. As a safety precaution however, you should recheck all fi ttings for leaks before using your Weber fi replace. Shipping and handling may loosen or damage a gas fi tting.
  • Page 15 NOT OPERATE THE FIREPLACE. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.
  • Page 16 fi replace. Replace using only Weber replacement hose. Contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber. ® Remove rain shields. DANGER Failure to remove rain shields while igniting the fi...

  • Page 17: Manual Lighting

    OPERATING INSTRUCTIONS MANUAL LIGHTING Remove rain shields. DANGER Failure to remove rain shields while igniting the fi replace’s burners, or not waiting 5 minutes to allow the gas to clear if the fi replace does not light, may result in an explosive fl ame-up which can cause serious bodily injury or death.

  • Page 18: Troubleshooting

    HIGH. Flames do not ignite all burner holes. If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com TROUBLESHOOTING CHECK Inspect Spider / Insect Screen for pos- sible obstructions.

  • Page 19: Annual Maintenance

    Do not dislodge the spider/insect screen or enlarge the screen opening. If the spider/insect screen becomes damaged or cannot be cleaned, call Weber-Stephen Products Customer Service for replacement parts. MAIN BURNER CLEANING PROCEDURE Turn off the gas supply.

  • Page 20: Main Burner Flame Pattern

    MAIN BURNER FLAME PATTERN ® The Weber gas fi replace burner has been factory set for the correct air and gas mixture. A correct fl ame pattern is: • A yellow to light-orange fl ame An incorrect fl ame pattern is: •...

This manual is also suitable for:

39995

Table of Contents