Advertisement
Crate&Barrel
LINEA BED - WITH SLATS
ASSEMBLY INSTRUCTION FOR BED INSTALLATION
IN YOUR PACKAGE :
ASSEMBLY INSTRUCTION
HARDWARE ( AS LISTED ABOVE )
PARTS TO BE INSTALLED
1. HEADBOARD
2. FOOTBOARD
3. SIDERAILS
4.
CENTER SUPPORT
5.
CENTER LEG
6.
SLATS
NOTICE
re l
& B ar
C ra te
SYMBOLS
DIRECTION
PERSON NEEDED
1pc
1pc
2pcs
1pcs
1pc
13pcs
1
3
X2
NUMBER OF
HARDWARES
SCREW Ø6 x 3'
6
4
5
USE HAND
SCREW Ø6 x 2'
(4X)
(1X)
SCREW Ø4 x 2cm
NUT
(4X)
(32X)
TOOLS (Not Included in Package)
RUBBER HAMMER
3
2
USE SCREW DRIVER
TO TIGHTEN
1/3
WASHER
(4X)
METAL CORNER
(4X)
SCREW DRIVER
DRILLING MACHINE
USE DRILLING
MACHINE
Advertisement
Table of Contents
Related Manuals for Crate&Barrel LINEA BED WITH SLATS
Summary of Contents for Crate&Barrel LINEA BED WITH SLATS
- Page 1 Crate&Barrel LINEA BED - WITH SLATS ASSEMBLY INSTRUCTION FOR BED INSTALLATION HARDWARES SCREW Ø6 x 3' SCREW Ø6 x 2' WASHER (4X) (1X) (4X) SCREW Ø4 x 2cm METAL CORNER IN YOUR PACKAGE : (4X) (32X) (4X) ASSEMBLY INSTRUCTION HARDWARE ( AS LISTED ABOVE ) PARTS TO BE INSTALLED TOOLS (Not Included in Package) 1.
- Page 2 Crate&Barrel LINEA BED - WITH SLATS ASSEMBLY INSTRUCTION FOR BED INSTALLATION CONNECTING SIDE RAIL AND HEAD / FOOT BOARD SIDE RAIL HEAD BOARD FOOT BOARD SIDE RAIL INSTALLING METAL CORNER...
- Page 3 Crate&Barrel LINEA BED - WITH SLATS ASSEMBLY INSTRUCTION FOR BED INSTALLATION INSTALLING CENTER LEG + CENTER SUPPORT CENTER SUPPORT CENTER LEG Position Tighten the screws if needed - INSTALL THE CENTER LEG FIRST. - USE SCREW Ø6x2' INSTALLING SLATS NOTE: - SLATS TO BE ASSEMBLED ARE NUMBER.
Need help?
Do you have a question about the LINEA BED WITH SLATS and is the answer not in the manual?
Questions and answers