Blind Spot Warning (Bsw) (With Lane Change Assist) - Mitsubishi MOTORS OUTLANDER Owner's Manual

CAUTION
• Obstacles that are shaped with a sharp an-
gle.
• A fence with large mesh
• Moving object
• When there is a loud noise or an ultrason-
ic near your vehicle by horn of other vehi-
cle, engine sound of a motorcycle, air
brake noise of a large vehicle, a vehicle
detector and sonar of a vehicle etc.
• When an electrical equipment on the mar-
ket (radio antenna etc.) is installed near
the sensor.
• When there is a obstacle that is not recog-
nized between your vehicle and the obsta-
cle that can be recognized.
NOTE
The sensors do not detect objects located in
l
the area directly below or near the bumper.
If the height of an object is lower than the
mounted position of the sensors, the sensors
may not continue detecting it even if they
detected it initially.
To turn on/off the UMS
E00643800082
The UMS is automatically turned ON by set-
ting the ignition switch or the operation mode
to ON. In addition, the UMS ON/OFF is
switched in conjunction with the ON/OFF
state of the FCM.

Blind Spot Warning (BSW) (with Lane Change Assist)*

Refer to "FCM and UMS ON/OFF switch"
on page 6-97.
Warning display
E00643900025
When the sensor is temporarily
not available
E00647600033
Example: When the front and/or rear sensors
are temporarily not available
When the warning display appears, the sen-
sors are temporarily not available for some
reason such as the environmental condition
or increase of the sensor temperature. When
the warning display appears continuously,
contact a MITSUBISHI MOTORS Author-
ized Service Point.
When there is a malfunction in
the sensor or the system
E00644000036
Example: When there is a malfunction in
both sensors
OGFE19E1
When the warning display appears, the Ultra-
sonic misacceleration Mitigation System
does not operate normally because there are
some malfunctions in the system. Have the
vehicle inspected at a MITSUBISHI
MOTORS Authorized Service Point as soon
as possible.
Blind Spot Warning (BSW)
(with Lane Change Assist)*
E00644300143
The Blind Spot Warning (BSW) is a driving
aid system that alerts the driver when another
vehicle, which may not be visible through the
outside rear-view mirror, is travelling in the
next lane behind your vehicle.
When a vehicle in the next lane is travelling
at the same speed or faster in the detection
areas, the Blind Spot Warning lamp in the
corresponding outside rear-view mirror will
illuminate. If the turn-signal lever is operated
to the side where the Blind Spot Warning
lamp is illuminated, the Blind Spot Warning
lamp will blink and the system will beep
three times to alert the driver.
Starting and driving
6
6-107