I) Testing Servo Positioning; Errors And Error Messages; Care And Cleaning - VOLTCRAFT V-CHARGE 600 DUO Operating Instructions Manual

i) Testing servo positioning

10. Errors and error messages

Error message
Message for problems with the bat-
tery connection, e.g. an error at the
battery or balancer contact
'Connection error, check connection'
Message for fluctuating input voltage
'Input voltage unstable'

11. Care and cleaning

Never use aggressive detergents, rubbing alcohol or other chemical solutions, as these may damage the
housing or stop the product from functioning properly.
• Disconnect the product from the mains before cleaning. Pull the mains plug from the mains socket or remove the
DC power supply.
• Use a dry, lint-free cloth to clean the product.
• To prevent scratch marks, do not press too strongly on the surface of the enclosure and LC display when cleaning.
30
• Use the Servo connection (6) to connect a motor and test the direction and
angle.
• Press and hold the rotary switch for the charging channel 2 (10) for a few
seconds to open the test menu for the servo.
• Turn the rotary switch for the charging channel 2 (10) to change the pulse
width and, at the same time, to check the response of the servo arm of the
connected servo motor. The change of the pulse width is shown on the LC
display (9) at the same time in the form a graph.
Possible cause
Soiled contacts
Soiled contacts
The max. input voltage is not
set correctly.
Proposal for troubleshooting
Ensure that the contacts are free of
dirt and grease and not oxidised.
Ensure that the contacts are free of
dirt and not oxidised.