1. Manuals
  2. Brands
  3. LSI LASTEM Manuals
  4. Measuring Instruments
  5. Heat Shield
  6. Quick user manual

LSI LASTEM Heat Shield Quick User Manual

Hide thumbs Also See for Heat Shield:
1
2
3
4
5
6
7
8
9
Table of Contents

Advertisement

Quick Links

Download this manual
Heat Shield
Quick user's guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Heat Shield and is the answer not in the manual?

Questions and answers

Related Manuals for LSI LASTEM Heat Shield

Summary of Contents for LSI LASTEM Heat Shield

  • Page 1 Heat Shield Quick user's guide...

  • Page 2: Instrument Description

    INSTRUMENT DESCRIPTION LCD display 4x20 chr. (1 ) - Keyboard (2) - Base mounting (3) - Tripod mounting (BVA325) (4) - Reset (5) - Power supply / battery charger (6) - Anemometer input (7) - RS232 port (8) - Wet bulb temperature sensor (9) - Air tempetaure sensor (1 0) -...

  • Page 3: Switch On/Off

    . Press to confirm. Press to exit. Measurement display Heat Shield shows measurements and indexes from its sensors and, when connected, from satellite units. moves to different group of measurements/indexes. to scroll the group to the next/previous one. scroll vertically each group.

  • Page 4: Data Storing

    Go to SURVEY for more infor- Press to stop data mation. storing Status bar It contains some Heat Shield working information: where: storing in progress. survey number. shh:mm: can have the following meanings: - If programmed, it is the time to reach the starting time of the survey (s=”-“).

  • Page 5: Survey Setup

    Attention: radiant temperature sensor would need 20 minutes to acclimatize. Survey setup Go to Survey setup. Nr survey. Heat Shield assign one number to each survey. It is possible to change (1 .99) the assigned number during measurement. Mode: Heat Shield can performs measurement from the base unit only (WBGT1 amb), from base unit plus one satellite (WBGT 2 amb), from base units plus two satellite units (WBGT 3 amb).

  • Page 6: Installation

    Installation Run Setup and follow its instructions During the first run, the program asks to install a new Heat Shield unit. Connect Heat Shield base unit to PC using it cable and USB adapter. To recognize the PC port where Go to “Communication”...
  • Page 7 EXAMPLES Fig. 1 - WBGT 1 environment measurement and index from Base unit only. Fig. 2 - WBGT environments: separate measurements and indexes from base unit and one satellite unit.
  • Page 8 1 70 cm 11 0 cm 11 0 cm 60 cm 1 0 cm 1 0 cm Fig. 3 - Installation of the units in the case of WBGT Subject . Fig. 4 - WBGT subject: Fig. 5 - Usage of WBGT 1 env. measurements and indexes with cup anemometer.
  • Page 9 www.lsi-lastem.com...

Table of Contents