Summary of Contents for Jandy JANDY RAY-VAC H0555100
Page 1
Operating Data Owner's Manual WARNING FOR YOUR SAFETY - This product must be installed and serviced by authorized personnel, qualified in pool/spa installation. Improper installation and/or operation can create a hazard which can cause serious injury, property damage, or death. Improper installation and/or operation will void the warranty.
TABLE OF CONTENTS SECTION 1 Safety Information Safety Instructions... 1 SECTION 2 General Information Introduction... 2 SECTION 3 Emptying the Ray-Vac Unit Emptying the Debris Compartment... 2 SECTION 4 Skimmer Guard Skimmer Guard Installation... 3 SECTION 5 Remove Ray-Vac Hose from Pool Wall Quick Disconnect...3 Equipment Information Record Date of Purchase...
Water Pik Technologies, Inc. SECTION 1. Safety Information 1A. Safety Instructions READ AND FOLLOW THESE SAFETY INSTRUCTIONS! PLEASE SAVE THESE INSTRUCTIONS 1. Handrails which extend into the water must be removed or substituted with a figure four design so as not to obstruct the movement of the cleaner. 2.
Page 2 SECTION 2. General Information 2A. Introduction ® The Jandy Ray-Vac automatic pool cleaner is designed to both vacuum and sweep your swimming pool. The cleaner head moves in a random submerged pattern about the pool, traveling, vacuuming and cleaning from the pool floor to the water line.
Water Pik Technologies, Inc. If the pump(s) is on: put your hand over the hole in the back of the cleaner and force the water back into the cleaner. Use the whip hose to further remove any debris. If the pump(s) is off: use a garden hose to remove debris.
Page 4 SECTION 6. Speed Adjustment After Cleaning Energy efficient Ray-Vac pool cleaners plumbed with a Jandy Energy Filter and valve require adjustment of speed after each cleaning of the main filter. If your Ray-Vac operates with a booster pump, this adjustment will not be necessary.
Page 7
Water Pik Technologies, Inc. Check the Finger Screen (at rear of Hydro-Timer) If it is clogged, use the following steps to clear: Grasp and hold the Hydro-Timer while you unscrew the Finger Screen Case. Remove the Finger Screen and rinse it off. Place the Finger Screen back into its case and tighten onto the Hydro-Timer.
Page 6 SECTION 7. Ray-Vac Maintenance It is important to maintain the Ray-Vac as demonstrated to insure the unit a longer life. 7A. General Maintenance Clean main filter (see Manufacturers Owner Manual). Clean Energy Filter (see Section 6 "Speed Adjustment after Cleaning"). Clean Finger Screen (see Section 6 "Speed Adjustment after Cleaning").
Water Pik Technologies, Inc. SECTION 8. Troubleshooting 8A. Troubleshooting Problem Cause Pool Cleaner Corner restricting movement of stalls in corner. movement of Ray-Vac. Nose caster wheel jammed with debris. Clean or replace. Increase backup. Pool Cleaner Skimmer opening is larger than stalls in skimmer.
These warranties extend only to the first retail purchaser of Laars and Jandy products that have not been moved from their original installation sites. Laars and Jandy warrants all parts to be free from manufacturing defects in material and workmanship as detailed below for the designated time frame, commencing from the date of installa- tion.
Need help?
Do you have a question about the JANDY RAY-VAC H0555100 and is the answer not in the manual?
Questions and answers