Table of Contents
Summary of Contents for LONGONI VITRA
- Page 1 LONGONI DIVISIONE FREDDO SRL Via Bongiasca,762/1 - 21020 – COMABBIO/VA – ITALY- Tel.++39/0331/968741 – Fax +39/0331/968721 – longoni@longoni.it...
-
Page 2: Table Of Contents
T A B L E O F C O N T E N T S GENERAL INFORMATION page 3 MANUFACTURER SERVICE CENTERS CERTIFICATIONS WARRANTY PREARRANGEMENTS BORNE BY THE CLIENT STRUCTURE OF THE MANUAL 1.6.1 SCOPE AND CONTENT 1.6.2 INTENDED READERS 1.6.3 CONSERVATION OF THIS MANUAL 1.6.4 SYMBOLS USED DESCRIPTION AND FUNCTIONING... - Page 3 FUNCTIONING: page 11 OPERATORS PUTTING INTO OPERATION START - UP AND CONTROL PANEL 7.3.1 CONTROL PANEL FUNCTIONS TEMPERATURE ADJUSTMENT 7.4.1 DISPLAY SYMBOLS 7.4.2 DEFROSTING 7.4.3 TEMPERATURE DISPLAYED 7.5 ALLARM 4.5.1 ALLARM LIST STORAGE OF FOOD ITEMS PRESERVATION OF FOOD ITEMS ORDINARY AND SCHEDULED MAINTENANCE page 20 SAFETY STANDARD REGULATIONS...
-
Page 4: General Information
1.1 THE MANUFACTURER Longoni Div. Freddo was founded in 1983 and quickly established itself as a leader in the sector of refrigerated display cases. It is thanks to the company’s dynamic commitment to research, innovation and ongoing development of new products that Longoni has become one of the world's most prestigious brands in the refrigerator industry. -
Page 5: Structure Of The Manual
1.6 S T R U C T U R E OF THE MANUAL The Client must carefully read the information contained in this Manual, in that proper prearrangements and correct installation and use of the refrigerator are the basis of a profitable Client - Manufacturer relationship 1.6.1 SCOPE AND CONTENT The purpose of this Manual is to provide all the necessary information to enable the client to use and manage the apparatus in the most safe and autonomous manner possible. -
Page 6: Description And Functioning
2 . D E S C R I P T I O N A N D F U N C T I O N I N G 2.1 DESCRIPTION The display cases are fitted with air - condensed refrigerator units composed of the following parts (as regards the electrical system): ... -
Page 7: Supplies Upon Request
3.3.1 SUPPLIES UPON REQUEST It is understood that modifications and/or addition of components are subject to manufacturer's approval and must be made by the manufacturer himself. Operators/and or maintenance staff are expressly forbidden from making any odification or alteration to the refrigerator due to the safety risks involved. -
Page 8: Hazardous Areas
Turn off the master switch. Unplug the power supply cable. 4.6 LABEL PLATES Modello/Model Matricola/Series N. Gas : R452/A - gr… Cap. : Volt : - Hz : - Watt: - Classe: N LONGONI DIVISIONE FREDDO S.r.l. V.Bongiasca, 762/1-COMABBIO(VA)ITALY-tel.0331/968741-fax 0331/968721 www.longoni.it longoni@longoni.it... -
Page 9: Shipping And Handling
S H I P P I N G A N D H A N D L I N G PLEASE READ THE INFORMATION CONTAINED IN THIS MANUAL VERY CAREFULLY AS IT PROVIDES IMPORTANT GUIDELINES FOR SAFE INSTALLATION, USE AND MAINTENANCE OF THE APPARATUS BE SURE TO STORE THIS MANUAL IN A SAFE PLACE FOR ANY FUTURE REFERENCE. -
Page 10: Storage
STORAGE If a long period of inactivity is foreseen, the refrigerator must be stored with the precautions related to the storage site and storage period. In this respect: Store the display case in a secluded place; Make sure it is protected against accidental bumping and stress; ... - Page 11 Fig.3 Fig.4 Before putting the refrigerator into operation, wipe down all its parts with a clean, soft cloth, or spray it with an all-purpose cleaner. Use very little water as it contains suspended mineral matter, that needs to be wiped off almost immediately as it may leave traces that are difficult to remove. ...
-
Page 12: Prearrangements
PREARRANGEMENTS Make sure the cable sections and the plug are suitable for the power absorbed by the apparatus. IT IS FORBIDDEN TO USE CABLE EXTENSIONS, ADAPTORS AND MULTIPLE - OUTLET SOCKETS Be careful not to install the refrigerator near to heat sources, such as ovens, radiators, direct sunlight, etc. ... -
Page 13: Putting Into Operation
PUTTING INTO OPERATION In case the refrigerator was shipped in a horizontal position, leave it upright for 2 hours or so before putting it into operation. START UP AND CONTROL PANEL Tools needed: Screwdriver (Philips Head) Use the screwdriver to remove the 4 screws located on the rear panel (Fig. 7). ... -
Page 14: Control Panel Functions
7.3.1 CONTROL PANEL FUNCTIONS A self-test on the touch instrumentation integrated in the refrigerator door will automatically run as soon as the plug is inserted. Once the test is completed, the central red button shall remain lit, and from this point on, the refrigerated display case can be switched on. ( Fig. 9). Fig.9 ... - Page 15 Press the upper button to increase the value , the down button to decrease, press the right Button to move to the day. Press the upper button to increase the value , the down button to decrease, press the right Button to move to the hour.
-
Page 16: Temperature Adjustment
7.4 TEMPERATURE ADJUSTAMENT To set the temperature, proceed as follows : Press the central button until appeared the Home Page.. Home page Press two times the button right until appeared the temperature icon. Press the central button, the set point temperature appeared, adjust the temperature with Button UPPER AND DOWN , press the central button until confirm the value. -
Page 17: Temperature Displayed
TEMPERATURE DISPLAYED Is possible control the temperature in the refrigerated cabinet in two ways: EASY and SCIETIFIC. To Select the easy or scientific press two times the central button. SWITCH OFF REFRIGERATED CABINET Press the central button the home page appeared, press one time the right button the OFF icon Appeared , press the central button until the refrigerated cabinet switch off. -
Page 18: Allarm
7.4.3 ALLARM When there is temperature alarm, the alarm icon appeared and the central button flashing Press the central button and the alarm list appeared. If there are a failure the failure icon appeared and the central button flashing. Press the Central button the failure list appeared. -
Page 19: Allarm List
7.5.1 ALLARM LIST... -
Page 20: Storage Of Food Items
7.6 STORAGE OF FOOD ITEMS To achieve the best performance from your refrigerator, please follow the advice below; Do not introduce hot foods or uncovered liquids into the refrigerator; Provide additional protection/packaging to foods, in particular those that contain strong aromas or cream;... -
Page 21: Ordinary And Scheduled Maintenance
8.1 SAFETY STANDARD REGULATIONS Before performing any kind of maintenance work, shut down the refrigerator and disconnect the plug from the outlet. 8.1.1 PROHIBITION AGAINST REMOVAL OF SAFETY DEVICES It is strictly forbidden to remove the guards for carrying out ordinary maintenance works The manufacturer shall not be held liable for any accident due to non-fulfilment of the foregoing requirement. -
Page 22: Periodical Checks And Inspections
8.1.5 PERIODICAL CHECKS AND INSPECTIONS The integrity of the electric cables and appliances should be checked on a periodical basis. 9. S P E C I A L M A I N T E N A N C E A N D R E P A I R S Extraordinary maintenance and repair works must be carried out exclusively by specialized staff and only prior to manufacturer’s authorization. -
Page 24: Spare Parts
11. S P A R E P A R T S 11.1 SUPPLY OF ORIGINAL SPARE PARTS Any replacement part can be purchased at our authorized centres. When making your request, the following information must be provided: Model and Serial N° (See label plate A); ... - Page 25 DECLARATION DE CONFORMITE DECLARACION DE CONFORMIDAD KONFORMITATSERKLARUNG Il sottoscritto designato a legale rappresentante della LONGONI DIVISIONE FREDDO Srl, Via Bongiasca 762/1 –COMABBIO/VA– ITALIA dichiara che l’apparecchio di refrigerazione per uso commerciale, al quale questa dichiarazione si riferisce, è conforme alle seguenti direttive: The undersigned, an authorized officer of LONGONI DIVISIONE FREDDO Srl, Via Bongiasca 762/1 –...
Need help?
Do you have a question about the VITRA and is the answer not in the manual?
Questions and answers