Table of Contents
Advertisement
kite
IMPORTANT! READ CAREFULLY AND
KEEP FOR FUTURE REFERENCE.
Read the instructions carefully before use and keep them for future reference.
The child may be hurt if you do not follow the instructions.
Adult assembly required.
Instruction Leaflet
Nebula
Complies with: BS EN 1130 - 1 : 1997 and BS EN 12227 : 2010
Customer Care Line: 01454 326 568.
Advertisement
Table of Contents
Related Manuals for KITE Nebula
Summary of Contents for KITE Nebula
- Page 1 Read the instructions carefully before use and keep them for future reference. The child may be hurt if you do not follow the instructions. Adult assembly required. Instruction Leaflet Nebula Complies with: BS EN 1130 - 1 : 1997 and BS EN 12227 : 2010 Customer Care Line: 01454 326 568.
- Page 2 Parts list 1. Frame with foot board + mattress. 2. Crossbar. 3. Feet x2. 4. Side support frames x2. 5. Bassinette crib liner. 6. Crib liner support bar. 7. Bolts x2 and Allen key. 8. Bed fixing belts. 9. Carry bag - not shown. Assembly instructions Fig 1 1.
- Page 3 Crib Mode Fig 5 5. Slide the bassinette crib liner support bar into the crib liner pocket and attach the liner to the inside of Liner the crib with the zip. Fig 5. and insert the mattress Fig 5a. Pocket on underside 6.
- Page 4 Playpen Mode Drop the height of the crib Fig 9 9. Undo the press studs and undo the outer zips located on the bottom of the crib section. Fig 9a. Drop the height of the crib to its Press stud lowest height and press the foot board clips on to the cross bar to secure in place.
- Page 5 Co Sleeper Mode 2 Lift Fig 10 10. Unzip the front panel on both 1 Slide sides. Fig 10a. Slide the buttons sideways and lift the bar upwards on both sides. Fig 10b. Roll the bar and panel up and secure with the elastic loops.
- Page 6 INCORRECT CORRECT Bed frame and mattress not in line Bed frame and mattress in line Never use the Nebula Crib in co sleeping mode without the anchor plate. Ensure the plates are securely attached to the adult bed. Anchor plates...
- Page 7 13. Move the co sleeper next to the Fig 13 parents bed and check the height of the co sleeper compared with the mattress on the bed. Fig 13. The side support of the co sleeper should always be placed close to the parents mattress.
- Page 8 Failure to do this may invalidate your warranty. • DO NOT use crib if any parts are missing, damaged, or broken. Contact Red Kite for replacement parts and instructional literature if needed. DO NOT substitute parts.
- Page 9 • Failure to follow these warnings and instructions could result in serials injury or death. • Never use the Nebula crib in co sleeper position without the anchor plate attached and locked as shown in the instructions. Failure to use this anchoring system could result in serious injury or death to the infant. Make sure all straps are secured and tight.
- Page 10 Warnings: • WARNING! Do not use this product without reading the instructions first. WARNING! – Stop using the product as soon as the child can sit or kneel or pull itself up. WARNING! – Do not place additional items (e. g . toys, pillows…) in the product. WARNING! –...
- Page 11 • Use this product with only one child at time. • Always use the playpen with the drop side rail in place. • Complies with: BS EN12227 : 2010 Imported by The Red Kite Baby Co Ltd 35 Lavenham Road Beeches Industrial Estate Yate...
Need help?
Do you have a question about the Nebula and is the answer not in the manual?
Questions and answers