PRE-DELIVERY CHECK LIST INTRODUCTION THANK YOU Check the following before you deliver the Aerator to the Thank you for purchasing a CLASSEN Aerator customer. READ THIS MANUAL 1. Guards and shields fastened in place. Read this manual carefully in its entirety. It contains safety, 2.
SAFETY PRECAUTIONS TRAINING OPERATIONAL SAFETY 1. Regard the unit as a piece of power equipment and teach 1. Carefully read and follow all caution decals. (See Pg. 5.) this regard to all who operate this unit. 2. Operate only in daylight or good artificial light. 2.
6. For maximum tine penetration into turf, apply downward pres- sure on handle. 1. Turn fuel cock to the “open” position. Models CA-18, TA-19D & TA-19B : At the end of aerating 2. Turn choke on (closed). run, release control handle and lift up on lowering handle. Turn 3.
2. Take off pulley guard (see Fig. 2) by removing bolts, etc. which FOLLOWING: attach it to the frame. • When replacement parts are required, use genuine Classen parts or parts with equivalent characteristics including type, 3. Loosen the bolts, nuts, lock washers, and flat washers (Key 4) to strength, and material.
AERATOR STORAGE SAFETY DECALS WARNING SAFETY WARNING: TO PREVENT POSSIBLE EX- PLOSION OR IGNITION OF VAPORIZED FUEL, DO NOT STORE EQUIPMENT WITH FUEL IN TANK OR CARBURETOR OR NEAR OPEN FLAME (I.E. FURNACE, WATER HEATER, PILOT LIGHT). STORAGE INSTRUCTIONS Before the Aerator is put into storage for any period exceeding All Guards Must Be In 30 days, the following steps should be taken.
1028 Street Road • P.O. Box 38 Southampton, PA 18966 U.S.A. TWO YEAR LIMITED WARRANTY Effective April 1, 2007 For the period of two years from the date of purchase, Schiller Grounds Care, Inc. will repair or replace for the original purchaser free of charge, any part or parts found upon the examination of our factory authorized ser- vice station, or by the factory in Norfolk, Nebraska, to be defective in material or workmanship.
Page 13
SCHV-18/8.0 60RT Classen reserves the right to make changes or add improvements to its products at any time without incurring any obligation to make such changes to products manufactured previously. Classen, or its dis- tributors and dealers, accept no responsibility for variations which may be evident in the actual specifi- cations of its products and the statements and descriptions contained in this publication.
Need help?
Do you have a question about the TA-19D and is the answer not in the manual?
Questions and answers