Cleanmaxx VC9391 Instruction Manual page 20

EN
3. Check the colourfastness of the carpet or upholstered furniture. Soak a piece of
white fabric with the cleaning solution supplied (see the "Preparing the Device / Filling
the Fresh Water Container" section) and rub it carefully on an inconspicuous spot on
the carpet. If the white fabric does not become discoloured, the carpet or upholstered
furniture can be cleaned with the device. In the case of carpets or upholstered furni-
ture with several colours, test the fastness of each colour.
Preparing the Device / Filling the Fresh Water Container
PLEASE NOTE!
■ Only ever pour the cleaning agent supplied with the device or standard carpet clean-
ing products for carpet cleaners into the fresh water container.
■ Do not use any cleaning products that produce a lot of foam as excessive foaming
impedes the functioning of the device.
4. Fill the fresh water container (2) up to the Max mark with warm water (max. 40°C).
Close the seal cap again.
5. Insert the fresh water container
Initial Use" chapter).
Cleaning
PLEASE NOTE!
■ Switch off the device before a water container is removed.
■ Make sure that the device does not tip over. The water from the water containers
could spill out. To park the device, move the handle to the vertical position in which
it engages.
■ Do not wet the carpet or the upholstered furniture excessively.
■ If the device switches off during use, the built-in overheating protection has been ac-
tivated. In this case, let the device cool down for approx. 60 minutes and then switch
it on again using the On / Off switch.
20
1. Press the release lever of the fresh water container (15)
upwards. The fresh water container (2) is released from
the locking mechanism.
2. Remove the fresh water container (2) from the device.
3. Flip open the seal cap of the fresh water container (9) and
pour in carpet cleaning agent. Note the dosing instructions
for the cleaning agent when you do this.
(2) into the container support (14) (see the "Before