King Technology AQUA SMARTE Plus MINERAL ACTIVATOR Operational Instructions page 7

Replacing Aqua Smarte Plus Shine™, Optimize™ or MizerMax Pac™
Shine Optimize
2.
Turn Pac over and
shake slightly until
ingredients fall
into tower areas.
PAC
PAC
TOWERS TOWERS
Replacing Aqua Smart Plus CANNONBALL!™
See CANNONBALL! product labeling for complete directions for use (EPA Reg.: No. 53735-9).
1.
Remove cap from
CANNONBALL! without
removing seal.
NOTE: Wait 24 hours after
shocking before using
CANNONBAL!. Avoid adding
other chemicals until this
product has been circulated
(filtered) for at least 24 hours.
4.
Turn pump on for 90 minutes
allowing CANNONBALL! to
circulate through pool.
For an easy two-step pool closing program, use AQUA SMARTE Plus Shine
and Cannonball! following the directions above.
*Compared to the minimum EPA recommended chlorine level of 1.0 ppm for a stabilized swimming pool.
KING TECHNOLOGY, INC.
530 11th Avenue South, Hopkins, MN 55343 U.S.A.
WARNING
Avoid sparks, open flame or smoking when
handling the Aqua Smarte Plus Shine, Optimize
and MizerMax Pac.
Shine is a one time start-up product used to rid the
water of contaminants. Optimize - also used at start up,
sets the chlorine residual to help find the proper dial
setting for maintaining up to 50%* less chlorine while
using the MizerMax Pac (EPA Reg. No.:53735-2). All
MizerMax Pac three products sold separately.
3.
For a preventative dose, add one for pools up to 15,000 gallons or two for pools between 15,000 and 30,000 gallons.
2.
5.
952-933-6118 • 800-222-0169 • FAX 952-933-2206 • www.kingtechnology.com
Aqua Smarte
Plus Mineral
Activator
PAC
Line up the small leg of the
MizerMax Pac with the small
opening in the Mineral Activator
and the large leg with the large
opening. Lower MizerMax Pac
into Mineral Activator until
secure.
Insert upside down into
center of Mineral Activator
pushing down firmly on key
to puncture seal.
To remove
CANNONBALL!,
turn pump off,
Pac
turn dial to Pac
Removal
Removal, Setting 0
or OFF depending
on the model,
remove Docking
Station or Cycler
cap.
U.S. Patents 6,210,566; 6,217,892; 6,383,507; 6,544,415;
6,551,609; 6,652,871 and other U.S. and Foreign Patents Pending.
4
To remove colored
1.
COLORED caps, grab onto the
CAPS
lip of one cap with a
pliers and pull up until
cap releases. Repeat
the process for the
other cap.
4.
5.
Run the pump and filter for each pac according to
the directions on the product label. Remove from
the Docking Station or Cycler when empty and
discard or offer for recycling.
3.
4
Lift CANNONBALL! up and allow
6.
any water in the container to
drain through the System before
recycling or discarding in trash.
NOTE: If water shows more than
a hint of blue inside Docking
Station or Cycler, replace the cap,
turn dial to Maximum, Setting 5
or ON and run the pump for one
minute.
6A.
If pool size requires additional
CANNONBALL!, repeat steps 1-6.
6b.
When water is clear in
Docking Station or Cycler proceed
to Install MizerMax Pac.
EPA Reg. No.: 53735-11 EPA Est. No.: 071209-AZ-001
E063011553101143N 20-48-0171
Replace cap by
hand only.
DO NOT OVER
TIGHTEN.
Replace cap by
hand only. DO NOT
OVER TIGHTEN.
Turn control dial to
Maximum, Setting
5 or ON depending
on the model.