Advertisement
Vitra S20 Troubleshooting
Sticking or not flushing
Passing water
First check that the valve position is as shown above,
the valve should be clear of the cistern wall, if not
remove the valve and re-position.
If the valve position is correct, check the valve settings
are still in the factory set positions detailed in the table
(right).
If the problem persists please contact Siamp Aftersales
on 0161 681 2120 or aftersales@siamp.co.uk
✔
✘
No
Description
1
Stirrup
2
Lift Rod
3
Overflow
4
Residual Water
5
Short flush cursor
✘
Setting
Position 7 (number 6 will be visible)
Position 5 (4 holes above will be visible)
Factory set. D will be visible
0
10
✘
Figure
A
B
B
C
D
Advertisement
Table of Contents
Related Manuals for VITRA S20
Summary of Contents for VITRA S20
- Page 1 Vitra S20 Troubleshooting Sticking or not flushing Passing water ✔ ✘ ✘ ✘ First check that the valve position is as shown above, Description Setting Figure the valve should be clear of the cistern wall, if not Stirrup Position 7 (number 6 will be visible) remove the valve and re-position.
- Page 2 Vitra S20 Troubleshooting Sticking or not flushing Passing water Fig A. Fig B. Fig C. Fig D. Stirrup in position 7. Lift Rod in position 5 Residual Water set at 0 Short flush cursor set at 10 (number 6 will be visible)
Need help?
Do you have a question about the S20 and is the answer not in the manual?
Questions and answers