Display Information; There Is No Pump And Water - Beko BSS 4600 TT User Manual

3 Operation
6. If the appliance hasn't been used for a long
time, disconnect it from power after the
hot water cools down and drain the water
remaining in the hot water tank through the
drain channel by pushing the hot water tap.
7. Push the tap in order to drain the water in
the cold water tank, if water doesn't come out
of the cold water tap, please turn the cooling
switch off until water comes out.

3.1.4 Display Information

The degree of the hot water is shown at the right
of the display and the degree of the cold water is
shown at the left.

3.1.5 There is no pump and water

1. Press the ON/OFF button, the water dispen-
ser will switch to the idle mode. Pump symbol
appears on the display and the pump starts
working. When it reaches the water level, the
pump will stop working.
2. When the no water symbol is seen on the
display, the heating and cooling functions au-
tomatically stop. There is no water left in the
water bottle.
3. When putting water into the bottle, open the
door of the compartment, take the bottle out
by turning its collar. Place the new bottle in
the bottom compartment, put the lid on the
bottle and tighten it.
12 / 14 EN
Water Dispenser / User Manual