Table of Contents
Advertisement
The "Service mode" of the Standard Rinnai remote controller allows to read, adjust and modify some
parameters during the installation.
It is possible to adjust these parameters after the installation is performed to always adapt the appliance
operation to the end user's requirements.
To enter into "Service mode" it is necessary to:
1 - Press and keep pressed the (
2 - Press and keep pressed the (
3 - Press the DHW button (
(Push the buttons in the correct order, waiting 1÷2sec between them and make sure
that the CH and the DHW functions are disabled).
If the service mode is activated the symbol of a wrench appears in lower part of the display.
The number shown on the left side of the display refers to the parameter selected.
On the right side of the display is shown the current setting of the parameter shown.
- Use the left side arrows (1) & (2) of the remote to select the desired parameter.
- Press the DHW (3) button to adjust the value of the parameter.
- Press the CH button to exit the Service mode.
Below are reported the 14 parameters displayed in the service mode:
44
SERVICE MODE
) button on the remote (1).
) button on the remote (2).
) on the remote (3).
www.rinnai.it
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Mirai 24 and is the answer not in the manual?
Questions and answers