Product Specifications - Xpand Passive 3D Polarization Modulator Gen2 User Manual

cooling of the LC shutter will result in poor optical characteristics and may eventually lead to LC damage. Because of this the filter should
be cleaned regularly.
To clean the filter, first unplug the power from the unit. Next, place the protective cover on the modulator to prevent fingerprints or smudges
from getting on the polarizer, then slide the filter out of the unit and remove the filter from its holder. Clean the filter by blowing air through
it either by using an air compressor or a vacuum cleaner. If needed, wash the filter under water.
Remove the protective cover and plug the power jack back into the modulator.
If the filter shows sign of wear, it should be replaced.

Product Specifications

Product Name
Model Name
Active Area
Polarization
Transmittance
Efficiency
Response Time
Input Stereo Sync
Signal Frequency
Input Terminal 3D
Input LAN
© XPAND, All Rights Reserved.
Make sure the filter is completely dry before inserting it back into the unit!
XPAND Passive 3D Polarization Modulator Gen2
MS210C2
210 mm x 135 mm (8.3" x 5.3"), dual pi-cell technology
Circular Polarization (Circular Polarization Glasses)
40% (± 1%, may differ depending on the screen)
16% (varies with type of passive glasses used)
< 1 ms
24 Hz to 160 Hz, HFR support
GPIO 9 pin DB9 male connector.
Converter cables to DB15 and DB37 connectors commonly found on projectors are included.
8P8C (RJ-45/Ethernet) Connector
www.xpandvision.com