Table of Contents
Advertisement
H100
2.4G RC BOAT OPERATING
1.This product adopts 370 strong magneto drive system，uses the
advanced 2.4 G technology of frequency connection,Further remote
distance.
2.Configuration of lithium ion battery.The speed about 20KM/H.
3.The characteristic flip：While sailing ship capsizing can control the
boat flip, ensure correct voyage.
4.Motor cooling system: extending the service life of the model.
5.Have left,right side navigation rudder:enhanced stability.
6.Low voltage alarm function:when the deficiency of the model,the
remote controller will send out alarm.（After the alarm sounds,please
get the boat back immediately.prevent the model without electricity in
coming back.）
INSTRUCTIONS
14+
1
Advertisement
Table of Contents
Related Manuals for Skytech H100
Summary of Contents for Skytech H100
- Page 1 H100 2.4G RC BOAT OPERATING INSTRUCTIONS 1.This product adopts 370 strong magneto drive system，uses the advanced 2.4 G technology of frequency connection,Further remote distance. 2.Configuration of lithium ion battery.The speed about 20KM/H. 3.The characteristic flip：While sailing ship capsizing can control the boat flip, ensure correct voyage.
- Page 2 QR code for QR code for wechat skytech website...
- Page 3 RC boat main structure diagram switch of hatch hatch steering boat engine bar steering rudder guiding rudder outfall propeller Display racks Turn left Trim Turn right Trim backward trim forward trim throttle rocker direction rocker The default mode is left hand,press the button of turn left/right trim and open the power switch at the sametime.Then loosening the Trim button .Switched to the right hand mode when you listen a sound of “Di”.Restart it will be left hand mode.
- Page 4 Inserting battery battery cover 4 x ”AA” Inserting batteries:remove the battery compartment on the back of the remote controller and insert 4“AA” alkaline batteries,paying attention to the polarity markings in the battery compartment(batteries must be purchased separately. Charging the model battery Style 1: charger with balance charge 110-240V power supply.(selective buying) 1.Insert the plug 2.Connect the battery...
- Page 5 Intriduction of the Liquid crystal display forward/backward trim Turn left/Right trim Throttle/direction display NB:CH1 is forward display ,CH2 is backward display. CH3 is turn left display,CH4 is turn right display. Battery level: boat battery level signal Left/Right hand Mode...
- Page 6 Inserting battery into the boat fig.1 fig.2 fig.3 fig.6 fig.4 fig.5 1.To the right or left turn on the switch of cabin, open up the cabin cover. 2.Put the li-po into the battery holder of the hull. 3.Connect the battery and power plug. 4.The cabin cover oblique inserted into the hull.
- Page 7 fig.10 fig.11 fig.12 1.Put out the motor wire(see fig.1) 2.Put out the cooling rubbes hose(see fig.2) 3.Screw out the motor seat screw(see fig.3) 4.Remove the motor seat module (see fig.4) 5.Hold down the main shaft rubber pieces,using a wrench fig.13 lockout and propeller(see fig.5) 6.Put the spindle away a distance in the diection of the bow(see fig.6) 7.In amoderate amount of lubrication oil to the tail of the spindle tube.(see fig.7)
- Page 8 Operation method /left hand mode 1.Correction Throttle lever is pushed left，The direction of the rocker is pushed right, when have a sound of “di”,means correction was successed. 2.Forward Throttle lever is pushed forwards. The boat moves forward. 3.Backward Throttle lever is pushed backwards. The boat moves backward. 4.Turn left Throttle lever is pushed forwards and the direction rocker is pushed left at the same time.The boat turns left.
- Page 9 6.Yaw left trim Yaw left trim button When the ship on the voyage turn right automatic，press the yaw left trim button on the controller,boat will turn left slowly until it straight navigation. 7.Yaw right trim Yaw right trim button When the ship on the voyage turn left automatic，press the yaw right trim button on the controller,boat will turn right slowly until it straight navigation.
Need help?
Do you have a question about the H100 and is the answer not in the manual?
Questions and answers