Table of Contents
Advertisement
Available languages
Available languages
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
LED LIGHT FUNCTIONS
TOOL STATUS
Normal
Low Battery
Excessive Force
Over Temperature
*More than 9 flashes will result in the need to remove the battery and reinsert a few minutes later.
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
MAINTENANCE
TROUBLESHOOTING
LED LIGHT SCENARIO
Solid Light (No Flashes)
NOTE: ILLUSTRATIONS START ON PAGE 10
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
3 Flashes
6 Flashes
9 Flashes
9 - English
ACTION REQUIRED
No Action Needed
Replace Battery
Wait 5 Seconds
Let Tool Cool Off
- Quick Links:
- Symbols
- Operation
- Assembly
- Maintenance
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ONE+ PSBDD01 and is the answer not in the manual?
Questions and answers
My 1/2" PSBDD01 works for a few minutes then when I stop the drill the light stays on steady but the drill won't work again without removing and replacing the battery
The issue is likely due to the tool overheating. The Ryobi ONE+ PSBDD01 drill has a high temperature protection feature that deactivates the tool when it overheats. If the LED light flashes more than 9 times, the battery must be removed and reinserted after a few minutes to restart the tool.
This answer is automatically generated
@Mr. Anderson - I can't believe it is overheating. The LED light comes on when I start the drill as usual, but no matter hlw long I drill (10 seconds or extended time) when I release the trigger the light doesn't go out and trying to drill again doesn't start it back up. If I don't R&R the battery, the light stays on and doesn't stop until the battery is removed and replaced(R&R).
There is no page 11 !? The manual specifies that figure 8 is on page 11.