Toro DH 210 Setup Instructions
Hide thumbs
Also See for DH 210:
- Operator's manual (40 pages) ,
- User manual (188 pages) ,
- Operator's manual (40 pages)
Table of Contents
Advertisement
Quick Links
DH 210 and DH 220 Lawn Tractors
Model No. 74585—Serial No. 312000001 and Up
Model No. 74596—Serial No. 312000001 and Up
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Steering wheel
Roll pin
Spacer
Seat
Bolts
Adjusting knob
Flat washers
Spring washers
Collector cover
Cover frame
Handle
Spring washer
Handle screw
Screw
Steel washer
Rubber washer
Nut
Outer frame
Hinge pin
Snap ring
Grass collector dump lever
Grass collector dump lever screw
No parts required
No parts required
No parts required
No parts required
No parts required
Register at www.Toro.com.
Form No. 3373-128 Rev A
Qty.
1
1
Install the steering wheel.
1
1
2
2
Install the seat.
4
2
1
1
1
2
2
6
12
Assemble the grass collector.
12
6
1
2
2
1
1
–
Check the oil level.
–
Activate the battery.
–
Fill the Fuel Tank.
–
Check the tire pressure.
–
Lubricate the machine.
Setup Instructions
Use
Original Instructions (EN)
Printed in the Czech Republic
All Rights Reserved
Advertisement
Table of Contents
Related Manuals for Toro DH 210
Summary of Contents for Toro DH 210
- Page 1 Form No. 3373-128 Rev A DH 210 and DH 220 Lawn Tractors Model No. 74585—Serial No. 312000001 and Up Model No. 74596—Serial No. 312000001 and Up Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped.
-
Page 2: Installing The Steering Wheel
Installing the Steering Wheel Parts needed for this procedure: Steering wheel Roll pin Spacer Procedure 1. Position the front wheels straight ahead. G012505 2. Install the plastic spacer over the steering wheel shaft Figure 1 (smaller diameter first). 1. Safety switch 3. - Page 3 Assembling the Grass Collector Parts needed for this procedure: Collector cover Cover frame Handle Spring washer Handle screw Screw Steel washer Rubber washer Outer frame Hinge pin Snap ring Grass collector dump lever Grass collector dump lever screw G018122 Figure 3 Cross-sectional view shown Procedure 1.
-
Page 4: Checking The Oil Level
Checking the Oil Level No Parts Required Procedure The machine comes from the factory with oil in the engine crankcase; however, it may be necessary to add oil. Refer to the Operator’s Manual for oil type, viscosity, and crankcase capacity. Add only enough oil to raise the level to the Full mark on the dipstick. -
Page 5: Checking The Safety System
WARNING Charging the battery produces gasses that can explode. Checking the Safety System Never smoke near the battery, and keep sparks and flames away from the battery. No Parts Required 6. Install the filler caps after the battery is fully charged. 7. - Page 6 Notes:...
- Page 7 Notes:...