Moving Your Machine - Bowflex LateralX LX5 Service Manual

FCC Compliance
!
authority to operate the equipment.
The machine and power supply comply with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Note: This machine and power supply have been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Moving Your Machine

machine is wider than a standard room door frame. Disassembly may be required if transporting to a different area.
NOTICE: Always disconnect the power cord and power adapter from the wall outlet and the machine before attempting to move the
machine.
Use the Transport Handles at the rear of the machine to lift and move the machine. Your machine can be rolled on the transport wheels to a new
Do not use the handlebars, Console Mast, or the Console to lift or move the machine. Injury to you or damage to the machine can
occur.
The machine may be moved by one or more persons depending on
their physical abilities and capacities. Make sure that you and others
Place the machine on a clean, hard, level surface, free from unwanted
material or other objects that may hamper your ability to move freely.
A rubber mat should be used below the machine to prevent the
To prevent unsupervised operation of the machine always disconnect
the power cord from the wall outlet and machine power input. Place
the power cord in a secure location.
4