Getting Started - Ribimex PRCCELCD Series Original Instructions Manual

The safety precautions and instructions given in this manual are unable to cover in detail all the
conditions and situations that may arise.
The operator and/or user must use common sense and caution when operating the product
especially for any matters that are not referred in the above
14. Warning
The use of any accessory or attachment, other than those recommended in this instruction
manual, may present a risk of injury to persons or animals and may cause damages.
The user and/or operator are responsible for any damages or injury caused to properties and/or
persons.
15. Have your tool repaired by a qualified person
Repairs should only be carried out by qualified persons using original spare parts, otherwise it
may result in considerable danger to the user.
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected form
its power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Inserting and removing a socket
- To install a socket on the anvil (Fig 2):
Align the hole of the socket with the anvil and push down firmly.
Ensure it is centered and properly fixed.
- To remove a socket from the anvil :
Pull socket out firmly.
4.3- Switch (Fig. 3)
To operate tool, press on switch (2) (Fig.1).
To stop tool, release switch.
The switch (2) has 2 positions :
- on top: (R) to reverse (go counter-clockwise)
- on bottom: (F) to go forward (clockwise)
4.4- Torque adjustment (Fig.4)
- Press [a] to increase torque (max 350Nm in Tightening mode and
500Nm in Loosening mode)
- Press [b] to decrease torque (min 150Nm in Tightening mode).
4.5- IMPORTANT
THE TORQUE
The motor is protected by the electronic circuitry of the LCD display.
The power is managed by the electronic circuitry of the LCD display.
During operation, the machine provides the required power continuously for a period of 5 seconds
(which should be enough time for the normal tightening or loosening), the machine is then
protected by the electronic control unit (i.e. the motor is automatically shut down).
A rest period of 2 seconds is required before resuming work (before using the machine again).
INFORMATION ABOUT THE MACHINE
'
S USE AND
Fig. 2
Fig. 3
Fig.4
Page 17 / 28