Table of Contents
Advertisement
1
Explanation of symbols and safety instructions
1.1
Explanation of symbols
Warnings
In warnings, signal words at the beginning of a warning are used to
indicate the type and seriousness of the ensuing risk if measures for
minimising danger are not taken.
The following signal words are defined and can be used in this document:
DANGER:
DANGER indicates that severe or life-threatening personal injury will
occur.
WARNING:
WARNING indicates that severe to life-threatening personal injury may
occur.
CAUTION:
CAUTION indicates that minor to medium personal injury may occur.
NOTICE:
NOTICE indicates that material damage may occur.
Important information
The info symbol indicates important information where there is no risk to
people or property.
Additional symbols
Symbol
Meaning
▶
a step in an action sequence
a reference to a related part in the document
•
a list entry
–
a list entry (second level)
Table 1
TSS – 6720887696 (2018/05)
Explanation of symbols and safety instructions
1.2
General safety instructions
H Notice for the target group
These installation instructions are intended for
competent persons who are skilled in dealing with
water installations, heating and electrical systems.
▶ Read the installation instructions before starting
the installation.
▶ Observe the safety and warning instructions.
▶ Observe national and regional regulations,
technical rules and guidelines.
▶ Document all work performed.
H Intended use
The collectors are designed to produce heat in a
thermal solar system (thermosiphon system). The
installation set is exclusively designed for the safe
installation of collectors and the storage tank.
▶ Only operate collectors in hydraulically sealed
unvented thermal solar systems (no oxygen in the
pipework).
▶ Do not place other objects on the collectors.
H Risk of scalding at the DHW draw-off points
▶ In order to avoid scalding a mixer must be installed
in the DHW system that restricts the DHW
temperature to 60 °C. If in doubt, ask the specialist.
H Load bearing capacity of the roof
▶ Only install the product on roofs with sufficient load
bearing capacity.
▶ If in doubt, consult a structural engineer and/or
roofer.
H Storing the components
The supplied components may cause burns when
exposed to solar radiation.
▶ Protect the components from solar exposure. Wear
personal protective equipment.
▶ Store the collectors in dry conditions. If stored
outside, use a rain cover.
▶ Do not stand on the collectors.
H Working on the roof
There is a danger of falling when working on the roof if
measures are not taken to prevent accidents.
▶ If there is no independent anti-fall safety device,
wear personal protective equipment or safety
equipment.
▶ Observe accident prevention regulations.
3
Hide quick links:
Advertisement
Table of Contents
