Trouble Shootings - UNIS Pirate’s Hook 4p Operation Manual

Pirate's Hook 4p Manual

7. TROUBLE SHOOTINGS

7.1 Common Problem
Please confirm whether every connector connected tightly.
Symptom
Game will not
start
Circuit protector make power SW
Power cutting
Coin mech. fault or sample coin
Game will not
coin up
No ticket
dispensing
No sound
Display black
screen
Display blue
screen
Conflict between computer drive
16
06/25/2019
Possible Cause
Frame assembly connector is
loose.
Frame assembly fault
in cutting state
not installed.
Coin mech. signal cable loose.
IO control board no signal.
Out of ticket.
Ticket jamming.
Wrong connection.
Volume set too low.
Connector loose.
PCB fault.
Speaker fault.
POT installation error.
POT fault.
Audio cable problem.
PC crash.
Driver problem
Check connectors.
Display fault.
RAM is loose.
PC power cord is loose
VGA signal cable is loose.
PC video card is loose.
PC into protection
"0X000000A" code appears.
and software.
Recommended action
Plug the connector tightly.
Contact with UNIS Service.
Turn on power SW again. If appeared
again and again, machine has
anomaly. Please contact with UNIS
Service.
Change coin mech. or sample coin.
Check coin mech. signal cable loose.
Change IO board.
Add ticket and press reset button
Remove the jammed tickets and press
reset button.
Check the connections.
Raise the volume.
Plug in connector tightly.
Change PCB.
Change speaker.
Install POT correctly.
Change POT.
Reconnect the audio cable or change
it.
Restart or system recovery.
Restart the audio driver.
Plug in connector tightly
Vitalize another source such as a PC to
verity if the display is operational.
Pull it out and insert it again or change
main board or RAM.
Check PC power cord whether is loose.
Check VGA cable
Reseat video card.
Open front cover, if power on, light
flash all the time. Press power button
30s, then restart.
Uninstall or disable the new drivers or
software.