Manual Mode Settings; Auto Mode Setting - Honeywell T2 Pro User Manual

System operation settings
1 Press the Mode button to cycle to the next
available System mode.
2 Cycle through the modes until the required
System mode is displayed and blinking, and
confirm your selection with Select button.
System modes:
‒ Manual
‒ Auto
‒ Timer
‒ Schedule
‒ Off

Manual mode settings

1 When Manual mode is selected, Fan mode is
requested and can be cycled using
buttons, then Select button to confirm.
Fan modes:
‒ Pump Only
‒ High Cool
‒ Low Cool
‒ High Vent
‒ Low Vent
NOTE: Pre-wet always goes Off when Manual
mode is selected.
2 After Manual mode settings are completed, Fan
button can be used to change Fan mode from
Home screen.

Auto mode setting

1 When Auto mode is selected, indoor temp set up
is requested and can be increased or decreased
using or
confirm.
2 High Cool will start if set point is at least 2 ºC
below room temp. Once set point and room
temp are equal fan mode will change to Low
Cool until room temp will be 2 ºC below set
point and then turn off the system until set
point is 2 ºC below room temp.
NOTE: Pre-wet status will vary with Configuration
settings. If ON, Pump Only will start for 2 minutes
before it goes to High Cool.
3 After Auto mode settings are completed, Fan
button won't be available at Home screen.
4 Indoor temp set up can be modified with
buttons from Home screen.
buttons, then Select button to
or
or
2
AM
M on
Pre-Wet
On
Off
Mode Menu
MCR37418
AM
M on
Pre-Wet
On
Manual
Mode
Select Back
MCR37419
AM
M on
Pre-Wet
Off
Manual Pump Only
Mode
Select Back
MCR37420
AM
M on
Pre-Wet
Off
Manual Pump Only
Mode
Select Back
MCR37421
AM
M on
Pre-Wet
Off
Pump Only
Manual
Mode Menu Fan
MCR37422
AM
M on
Pre-Wet
On
Auto
Mode
Back
Select
MCR37423
AM
M on
Pre-Wet
On
Auto Hi Cool
Mode Menu
MCR37424