Glow-worm MicraCom 24c-AS/1 Operating Instructions Manual
Hide thumbs
Also See for MicraCom 24c-AS/1:
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Glow-worm MicraCom 24c-AS/1
Summary of Contents for Glow-worm MicraCom 24c-AS/1
- Page 1 Operating instruc- tions MicraCom 24c-AS/1 28c-AS/1 GB, IE...
-
Page 2: Table Of Contents
Contents Contents Guarantee and customer service ........11 Safety ..........3 11.1 Guarantee........11 Intended use ........3 11.2 Customer service......11 Qualification ........3 Appendix ..........12 General safety information..... 3 Eliminating faults....... 12 Notes on the documentation ..6 Troubleshooting ...... -
Page 3: Safety
Safety 1 1 Safety or mental capabilities or lack of experience and knowledge if 1.1 Intended use they have been given supervi- The product is intended as a sion or instruction concerning heat generator for sealed heat- use of the product in a safe way ing installations and for do- and understand the hazards in- mestic hot water generation. - Page 4 1 Safety ▶ Do not use naked flames (e.g. ▶ Do not tamper with any of the lighters, matches). safety devices. ▶ Do not smoke. ▶ Do not damage or remove ▶ Do not use any electrical any tamper-proof seals on components.
- Page 5 Safety 1 son drain the heating installa- tion. ▶ Only fill the heating installa- tion with suitable heating wa- ter and, in cases of doubt, ask a competent person about this. 0020289289_02 MicraCom Operating instructions...
-
Page 6: Notes On The Documentation
▶ Store these instructions and all other applicable documents for further use. Glow-worm is a licensed member of the Benchmark Scheme which aims to im- These instructions apply for the following prove the standards of installation and products only:... -
Page 7: Displayed Symbols
Function 5 4.4 Serial number Control Operation element You can find the serial number on the data – Go back one level plate and on the sticker on the upper side of the product. – Calling up the menu The serial number and the product desig- nation can also be found on a sticker un- –... -
Page 8: Setting The Heating Flow Temperature
5 Function ▶ (if no control is connected) or the message If oF is shown in the display, press the on and/or oF (if a control is connected). button to switch on heating mode. The basic display (B) shows the current ▶... -
Page 9: Care And Maintenance
Care and maintenance 6 ◁ The target domestic hot water tem- Note perature is displayed. If the heating installation ex- tends over several storeys, a Condition: Control connected higher filling pressure may be ▶ Switch off heating mode on the control required for the heating install- (→... -
Page 10: Checking The Condensate Discharge Pipe And Tundish
7 Troubleshooting Troubleshooting Note ▶ If you have been unable to eliminate A purging key can be used for the fault using the specified measures, the purging. consult a competent person. 7. Check the system pressure after pur- 7.1 Eliminating faults ging. -
Page 11: Decommissioning
For contact details for our customer ser- vice department, you can write to the ad- 9 Restarting dress that is provided on the back page, or you can visit www.glow-worm.co.uk. 1. Open the gas stopcock on the product if the gas stopcock is closed. 2. Press ◁... -
Page 12: Appendix
Appendix Appendix A Eliminating faults Message Possible cause Measure F.22 Water deficiency in 1. Check the filling pressure of the heating the heating installation installation. (→ Page 9) System pressure too 2. Fill the heating installation. (→ Page 9) F.28 After three unsuc- 1. - Page 16 Nottingham Road ‒ Belper ‒ Derbyshire DE56 1JQ Telephone 01773 824639 ‒ Technical helpline 0330 100 7679 After sales service 0330 100 3142 www.glow-worm.co.uk © These instructions, or parts thereof, are protected by copyright and may be reproduced or distributed only with the manufacturer's written consent.
Need help?
Do you have a question about the MicraCom 24c-AS/1 and is the answer not in the manual?
Questions and answers