Depth Stop Adjustment; Operation; Applications; Body And Hand Position - Craftsman CMXEMAX69434501 Instruction Manual

Depth stop adjustment (Fig. 18)
When used, the depth stop limits the downward travel
of the blade when doing non-through cuts.
• Unlock the head lock pin.
• Raise the saw head assembly.
• Turn the depth stop counter-clockwise to position
1
B to use the depth adjustment knob setting.
• Pull down on the saw head to check the current
setting.
• To change the setting, turn the depth adjustment
knob clockwise to decrease depth and counter-
2
clockwise to increase depth.
• When non-through cuts nished, turn the depth
stop clockwise to position A.
1
Fig. 18
A
B
2
A
1
Position A: for through cutting
Position B: for non-through cutting

OPERATION

When transporting the miter saw, turn o and unplug the
saw, then lower the saw head and lock it in the "DOWN"
position. Always use the carrying handle or hand holds
when lifting the saw.
WARNING: To avoid injury from an accidental start,
make sure the switch is in the OFF position and the
plug is not connected to the power source outlet.
WARNING: Do not allow familiarity with tools to
make you careless. Remember that a careless fraction
of a second is su cient to in ict serious injury.
WARNING: Always wear eye protection with side
shields marked to comply with ANSI Z87.1. Failure to
do so could result in objects being thrown into your
eyes, resulting in possible serious injury.
WARNING: Do not use any attachments or
accessories not recommended by the manufacturer
of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
1
2
2
2
B
1
WARNING: Never use another person as an additional
support for a workpiece that is longer or wider than
the miter table, or to help feed, support, or pull the
workpiece.

Applications

This product has been designed only for the purposes listed
below:
• Only cross cutting wood and wood-like products (do
not cut metals, ceramics or masonry products.)
• Bevel and compound cutting
• Cross cutting wide workpieces
WARNING: Never cut metals ceramics or masonry
products with this tool. This miter saw is designed for
use on wood and wood-like products only.
WARNING: Before starting any cutting operation,
clamp or bolt the compound miter saw to a
workbench. Never operate the miter saw on the oor
1 or in a crouched position. Failure to heed this warning
can result in serious personal injury.
WARNING: To avoid serious personal injury, always
tighten the miter lock handle and bevel lock knob
securely before making a cut. Failure to do so could
result in movement of the miter table or saw head
while making a cut.
WARNING: To reduce the risk of serious personal
injury, always wait for the blade to stop completely,
turn o the tool and disconnect it from the power
source before attempting to move it, change
accessories or make any adjustments.
WARNING: Before each use, verify that the blade is
free of cracks, loose teeth, missing teeth, or any other
damage. Do not use if damage is observed or
suspected.
NOTICE: Do not start the compound miter saw without
checking for interference between the blade and the miter
fence. Damage could result to the blade if it strikes the miter
fence during operation of the saw.

Body and hand position

WARNING: Never place hands near the cutting area.
Proper positioning of your body and hands when
operating the miter saw will make cutting easier and
safer. Keep children away. Keep all visitors at a safe
distance from the miter saw. Make sure bystanders
are clear of the saw and work piece. Do not force the
saw. It will do the job better and safer at its designed
rate.
Starting a cut:
• Place hands at least 3 in. (76.2 mm) away from the
cutting path of the blade.
• Hold workpiece rmly against the fence to prevent
movement toward the blade.
ENGLISH
15