Surefire ST07 User Manual page 2

REMOtE tAPE SWitcHES
INTERFACING TAILCAPS & REMOTE TAPE SWITCHES
CONNECT
To connect a tailcap and a remote tape switch, unplug the tailcap
connector cover and insert remote tape switch connector until it
clicks into place.
DISCONNECT
To disconnect remote tape switch connector from tailcap, grasp the
remote tape switch connector firmly then twist and pull.
SWITCH OPERATION
SR07
Press pressure pad for momentary activation; click pushbutton for
constant-on
SR07-D-IT
Press pressure pad with bump to activate Weapon Light
Press pressure pad w/o bump to activate auxiliary device
ST07
Press pressure pad for momentary activation
TAILCAP OPERATION
DS
Partially press for momentary activation; click for constant-on. If a
pressure pad is installed, see applicable instructions below
UE
Requires remote tape switch
XT
Push toggle switch left to enable system; Push toggle switch right
to disable (Fig 1). For momentary-on, press tailcap switch forward.
For constant-on, rotate tailcap toggle switches up or down; rotate in
opposite direction to turn light off (Fig 2).
SWITCH MOUNTING
SR07 / SR07-D-IT
Attach hook ends of remote tape switch to picatinny rail edges. Both
remote tape switches provide two areas for optional use of tie wraps
(not included) for added mounting security (Fig 3).
ST07
Use included alcohol wipe to clean the remote tape switch and
installation site of the firearm. Remove both strips of Velcro
(included) adhesive backing and apply to the desired mounting area
of the firearm, then adhere switch to the Velcro ® .
XT
Install tail cap by hooking hindges to the WeaponLight hinge pin (Fig 4).
DS00
UE
XT00
FIGURE 1
ENABLED DISABLED
FIGURE 3
®
ST07
SR07-D-IT
SR07
FIGURE 2
HOOK
FIGURE 4
HINGE
HINGE PIN