Intrusion Switch; Removing The Intrusion Switch; Installing The Intrusion Switch - Dell OptiPlex 7080 Small Form Factor Service Manual

Steps
1. Place the side cover onto the system aligning the tabs on the chassis.
2. Slide the side cover towards the front of the system until you hear the release latch click.
Next steps
1. Follow the procedure in

Intrusion switch

Removing the intrusion switch

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
About this task
The following image indicate the location of the intrusion switch and provide a visual representation of the removal procedure.
Steps
1. Disconnect the intrusion switch cable from the connector on the system board.
2. Slide the intrusion switch and lift it away from the system .

Installing the intrusion switch

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
20 Field service information
after working inside your computer.
before working inside your computer.