Battery Charging And Installation - Fisher-Price Imaginext Spike THE ULTRA DINOSAUR Quick Start Manual

• Plug the 9.6V NiMH battery connector into the charger connector.
• Plug the charger into a standard wall outlet. The charger L.E.D. turns red.
Notes: If power fl ow to the wall outlet is controlled by a switch, make sure the switch is "ON".
Use the charger only in a wall outlet. Do not plug the charger into a ceiling outlet. To connect to
a supply that is not in the United States, use an adapter (not included and sold separately) with
the proper confi guration for the power outlet.
• Charge the battery for four hours. When charging is complete, the charger L.E.D. turns green.
• Disconnect the charger connector from the battery connector. Unplug the charger from the
wall outlet.
Dinosaur
• Locate the battery compartment on the bottom of the dinosaur.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.
• Plug the 9.6V NiMH battery connector into the dinosaur connector.
• Fit the connectors into the back slot in the battery compartment and then place the 9.6V
NiMH battery pack on top.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.

BATTERY CHARGING AND INSTALLATION

9.6V NiMH
Battery Connector
Charger Connector
1.5V x 3
"AA" (LR6)
Remote Control
• Locate the battery compartment door on the bottom of the remote.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove the
battery compartment door.
• Insert three "AA" (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.
• Protect the environment by not disposing of this product with household waste
(2002/96/EC). Check your local authority for recycling advice and facilities.
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn
injury or ruin your product. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard
(carbon-zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely. Do not dispose of this product in a fire.
The batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the product before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
ICES-003
• This Class B digital apparatus complies with Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NMB-003
• Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
• L'utilisation de ce dispositif est autorisée seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et (2) l'utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement du dispositif.