Cleaning And Maintenance; Technical Specifications - Beurer FB 50 Instructions For Use Manual

Temperature
The display shows the current water temperature. To change the temperature press and hold the temperature button
(5) until you have set the desired water temperature (35, 38, 42, 45, 48 °C). The most pleasant temperature is in the
range 35 – 42 °C, the maximum temperature is 48 °C.
The temperature is factory-set to 35 °C.
Magnetic field and infrared
The footbath has 6 magnets and 8 infrared lights integrated into the bath. They promote your circulation and
stimulate the reflex zones.
Massage roller
You can experience a special massage effect by moving your feet back and forth on the six massage rollers integrated
into the bottom of the footbath. The massage rollers can optionally be removed by pulling them firmly upwards.
Removable attachments
Place the desired attachment on the holder in the centre. Press the attachment lightly down with your foot to
activate the electric motor.
The brush attachment can be used to stimulate the reflex zones in the soles of your feet
The massage attachment provides a soothing massage for your feet and promotes the circulation.
The corn and callus remover is used to remove dead skin cells and calluses.
The electric motor is protected from overheating and has a maximum load capacity. The motor stops if it is over-
loaded or overheated. It can be used again after cooling down.
Note
• Massage of a specific point on the sole of the foot may influence the corresponding organ of the body.
However, we recommend studying relevant literature and asking your doctor before using point reflex
zone massage to achieve the desired effect.
• The footbath can also be used without water.
After use pour the water out over the narrow side (11) of the footbath. Do not allow water to come into contact
with the display.

9. Cleaning and maintenance

Cleaning
WARNING
• Switch off the device each time before cleaning.
• Clean the device using only the methods specified. Under no circumstances may liquid enter the device
or accessories.
• Do not clean the device in a dishwasher.
• Do not use any abrasive cleaning products or hard brushes.
After use rinse the unit with tap water. The foot bath can be cleaned with a mild, non-foaming household cleaner,
e.g. neutral vinegar. To dry the air lines, switch to the bubble setting without water for approx. 1 minute.
Note
• Do not allow water to penetrate the interior of the footbath.
Care
If you do not plan to use the device for a long period of time, we recommend that you store it in the original packag-
ing in a dry environment, ensuring it is not weighed down by additional items.

10. Technical specifications

Supply 220-240 V~; 50-60 Hz; 390 W
15