Eaton Wright-Line ALLEPSD2430 Installation Instructions

ITEM NUMBERS
ALLEPSD2430
ALLEPSD3030
ALPEPSD2430
ALPEPSD3030

TOOLS REQUIRED

(1) 7/16" Socket wrench (not supplied)
(1) 3/8" Socket wrench (not supplied)
(1) 5/32" Allen wrench (supplied)
(1) Level (not supplied)
(1) Rubber mallet
IMPORTANT! The LMS Full Frame must be level
before installing the Service Pullout.

POSITIONING THE SERVICE PULLOUT

The Service Pullout can be installed at four different
heights at one inch increments. The minimum height is
34", the maximum height is 43". See figure 1.
1. Determine the desired height of the Service Pullout
and then insert the hooks* on the back of the unit into
the slotted standards and push down. See figure 2a.
To ensure that the hooks are seated, tap the top rear
corners with a rubber mallet.
*NOTE: It is suggested that the hooks be bent out
slightly to ease insertion into the slotted standards.
See figure 2b.
91712 Rev. __
S e r v i c e
I n s t a l l a t i o n
Hook
Bend out slightly
Figure 2a
Date:
P u l l o u t
Service Pullout
43" Maximum
34" Minimum
Hook Plates
Hooks
Figure 2a
1
LMS Full Frame
Service Pullout
Figure 1
Slotted standards